Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o EGR System) › from 2019.09
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0309414 ECD SYSTEM(w/o EGR System) J

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/o EGR System)  Turbocharger Noise  


DESCRIPTION

HINT:

Turbocharger noise is classified into 2 types. One is whistling noise, and the other is whining noise. When troubleshooting, the type of noise should be determined first.


Description
Noise Type Noise Description Main Trouble Area
Whistling noise The volume and pitch of this noise are proportional to the turbocharger speed or engine speed. Therefore, the noise level will become more obvious when the engine speed increases.
·

Turbocharger (e.g. shaft imbalance)

·

Gears inside engine

·

Transmission gear

·

Intake air system leakage

·

Intake air system breakage


Whining noise This noise has a lower pitch than whistling noise. It generally occurs in the engine speed range of 1500 to 2500 rpm, and has a relatively constant pitch, independent of engine speed and vehicle speed. Turbocharger
HINT:
·

Example: Vibration of turbocharger is transferred to exhaust pipe which causes resonation and noise.

·

Example: Vibration of turbocharger is transferred through exhaust pipe to vehicle body (floor) which then vibrates causing noise.




Faults and Symptoms of Diesel Engine Components


Turbocharger System
Main fault Turbocharger turbine shaft imbalance
Symptoms High-pitched whistling noise
HINT:

The pitch and volume change in proportion to the turbocharger speed.



Intake System
Main fault Leakage
Symptoms Leak flow noise

Gear inside Engine
Symptoms Gear noise
HINT:

The pitch and volume change in proportion to the engine speed.



Transmission Gear
Symptoms Gear noise
HINT:

The pitch and volume change in proportion to the transmission gear speed.




PROCEDURE

1.CONFIRM CONDITION IN WHICH NOISE OCCURRED
a.

Confirm with the customer the conditions in which the noise occurred.

HINT:

To clearly understand the conditions in which the noise occurred, the items in the table below are useful.


Item Note
Engine speed Engine speed range
Vehicle speed Vehicle speed range
Transmission gear Which gear?
Accelerator pedal position During acceleration or deceleration?
Temperature
·

Ambient temperature

·

Engine temperature (cold, warmed up, etc.)


Road conditions
·

City or highway driving

·

Uphill or downhill


Noise level
·

Did the noise occur suddenly, or build gradually?

·

Has the noise gradually been getting louder?


Other symptoms
·

Lack of power

·

High fuel consumption, etc.


Noise recognition What made the customer determine the noise to be abnormal?


Result:
Proceed to
NEXT



NEXT

2.CONFIRM NOISE CUSTOMER MENTIONED (PROCEDURE 2)
2.CONFIRM NOISE CUSTOMER MENTIONED (PROCEDURE 2)
a.

Check for the noise described by the customer.

HINT:

If a noise is heard, make sure that the noise matches the noise described by the customer.


Result:
Result Proceed to
Obvious abnormal noise matching noise described by customer is confirmed A
Obvious abnormal noise matching noise described by customer is not confirmed B




A

3.CHECK INTAKE SYSTEM

B

12.EXPLAIN TO THE CUSTOMER THAT THE NOISE IS NORMAL
3.CHECK INTAKE SYSTEM
a.

Check for air leakage between the air cleaner and turbocharger, and between the turbocharger and intake manifold.

HINT:
·

Check for disconnected or improperly connected hoses, and gaps between hoses and parts.

·

Check for foreign matter between the air cleaner and turbocharger.




Result:
Proceed to
OK
NG



OK

4.CONFIRM NOISE SOURCE (FROM TURBOCHARGER OR NOT)

NG

REPAIR OR REPLACE MALFUNCTIONING PARTS

4.CONFIRM NOISE SOURCE (FROM TURBOCHARGER OR NOT)
a.

Connect the GTS to the DLC3.


b.

Start the engine and warm it up.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VN Turbo Open.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the VN Turbo Open
50004 61 182

e.

Perform the Active Test under the conditions* from the time the noise occurred described by the customer and compare the noise to the noise heard when not performing the Active Test and check if the noise is reduced.

HINT:

*: Some examples of conditions are idling, racing the engine and driving at full throttle.


Result:
Result Proceed to
The noise is reduced (or disappears) A
The noise is the same as in Procedure 2 (The noise does not change) B


HINT:
·

When the variable nozzle of the turbocharger opens fully regardless of the engine condition, the turbocharger speed slows down and the cause of noise can be confirmed that is from the turbocharger or not.

·

If the turbocharger is the cause of the noise, the noise will be reduced when the variable nozzle opens because turbocharger speed does not increase.





A

5.CONFIRM THE NOISE TYPE

B

9.CHECK FOR NOISE FROM SOURCE OTHER THAN TURBOCHARGER (PROCEDURE 9)
5.CONFIRM THE NOISE TYPE
a.

Check whether the noise can be heard even when the engine speed is more than 3000 rpm, and whether the noise gradually gets louder as the engine speed increases.

HINT:

If so, the noise is likely to be whistling noise. If not, the noise is likely to be whining noise.


Result:
Result Proceed to
Yes (The noise is likely to be whistling noise) A
No (The noise is likely to be whining noise) B




A

6.REPLACE TURBOCHARGER SUB-ASSEMBLY

B

8.PERFORM ALIGNMENT OF EXHAUST PIPE AND CONFIRM THE NOISE
6.REPLACE TURBOCHARGER SUB-ASSEMBLY

Result:
Proceed to
NEXT



NEXT

7.CONFIRM WHETHER THE NOISE PROBLEM HAS BEEN SUCCESSFULLY SOLVED
7.CONFIRM WHETHER THE NOISE PROBLEM HAS BEEN SUCCESSFULLY SOLVED
a.

Check whether the noise problem has been successfully solved.


Result:
Proceed to
NEXT



NEXT

END

8.PERFORM ALIGNMENT OF EXHAUST PIPE AND CONFIRM THE NOISE
a.

Disconnect the exhaust pipe at the ball joint and from each exhaust pipe support, and then realign the exhaust pipe and reconnect it to each exhaust pipe support and at the ball joint.

HINT:

Refer to the Exhaust section.

Click hereEngine / Hybrid System>1VD-FTV (INTAKE / EXHAUST)>EXHAUST PIPE (except 5 Door)>COMPONENTS



b.

Confirm whether the noise problem is solved or not.

HINT:

The alignment of the exhaust pipe affects whining noise.


Result:
Result Proceed to
The noise problem is solved A
The noise problem remains B




A

END

B

9.CHECK FOR NOISE FROM SOURCE OTHER THAN TURBOCHARGER (PROCEDURE 9)
a.

Check for the noise source with a sound scope.

NOTICE:

When performing this check, make sure that the sound scope, your body, etc., do not get caught on the V-belt.


HINT:
·

The source of the noise is not the turbocharger, but a part other than the turbocharger (e.g. a part inside the engine, transmission, or vacuum pump).

·

Sometimes gear noise may be mistaken for turbocharger noise. For gear noise, pay attention to the gear inside the engine and transmission gear.

·

Rev the engine up and check if the noise reduces at the same time the engine speed decreases. If the noise reduces at the same time the engine speed decreases, it is gear noise. If the noise reduces a short time after the engine speed decreases, it is turbocharger noise.

·

The following illustration is a reference for checking whether the noise source is from the engine.



A234362C01
5.615,0.417 5.521,0.417 5.521,0.417 5.24,1.063 false 6.646,0.917 6.552,0.917 6.552,0.917 6.271,1.552 false 6.385,1.844 6.552,0.917 false 4.927,1.281 5.521,0.417 false 4.302,0.594 4.396,0.594 4.396,0.594 4.75,1.646 false 4.146,2.708 4.24,2.708 4.24,2.708 4.76,2.479 false 6.719,1.927 6.542,1.927 6.542,1.927 6.229,2.177 false 6.375,0.625 6.271,0.625 6.271,0.625 5.854,1.833 false 4.135,0.5 4.385,0.688 0.25,0.188 10 false *1 5.667,0.365 5.917,0.552 0.25,0.188 10 false *2 6.688,0.833 6.938,1.021 0.25,0.188 10 false *2 3.979,2.656 4.229,2.844 0.25,0.188 10 false *3 6.771,1.844 7.021,2.031 0.25,0.188 10 false *5 3.531,0.156 3.781,0.344 0.25,0.188 10 false *a 6.417,0.552 6.667,0.74 0.25,0.188 10 false *4
*1 Supply Pump Drive Gear *2 Camshafts
*3 Crankshaft *4 Oil Pump
*5 Scavenging Pump - -
*a Gear Location inside Engine - -


HINT:
·

Above illustration is an example.

·

Gear noise can be confirmed with a sound scope. Put the sound scope on the cylinder block near the gear, and if the noise heard through the sound scope has the same timing as the noise heard without the sound scope, it is gear noise.




Result:
Proceed to
NEXT



NEXT

10.REPLACE THE PARTS DETECTED IN PROCEDURE 9
10.REPLACE THE PARTS DETECTED IN PROCEDURE 9
a.

Replace the parts detected in Procedure 9 as the noise source.


Result:
Proceed to
NEXT



NEXT

11.CONFIRM WHETHER THE NOISE PROBLEM HAS BEEN SUCCESSFULLY SOLVED
11.CONFIRM WHETHER THE NOISE PROBLEM HAS BEEN SUCCESSFULLY SOLVED
a.

Check whether the noise problem has been successfully solved.


Result:
Proceed to
NEXT



NEXT

END

12.EXPLAIN TO THE CUSTOMER THAT THE NOISE IS NORMAL
a.

Explain to the customer that the noise the customer mentioned is not abnormal.

HINT:

To help the customer understand, test driving another car with the customer may be helpful.



Result:
Proceed to
NEXT



NEXT

END