Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
69206C 3.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH
69260E 4.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Power Window)
74240 7.REMOVE REAR ARMREST ASSEMBLY LH (w/o Power Window)
67604 8.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/o Power Window)
69759J 9.REMOVE DOOR LOCK LINK SILENCER
67842E 10.REMOVE REAR DOOR SERVICE HOLE COVER LH
69780A 11.REMOVE REAR DOOR INSIDE LOCKING LINK ASSEMBLY LH
69718B 12.REMOVE REAR DOOR LOCK REMOTE CONTROL LINK LH
68142 13.REMOVE REAR DOOR GLASS RUN
67408E 14.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68104 15.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
68240A 16.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP ASSEMBLY LH
69804 17.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/ Power Window)
69804 18.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/o Power Window)
67836 19.REMOVE REAR DOOR LOCK CHILD PROTECTION COVER
69340 20.REMOVE REAR DOOR LOCK ASSEMBLY LH
Detach the snap and disconnect the control link from the rear door outside handle assembly LH as shown in the illustration.
The control link can be easily removed by pushing the end of the control link with the tip side of a screwdriver.
w/ Power Door Lock:
Detach the clamp.
Disconnect the connector.
Remove the bolt.
Using a T30 "TORX" socket wrench, remove the 3 screws and rear door lock assembly LH.
w/o Power Door Lock:
Using a T30 "TORX" socket wrench, remove the 3 screws and rear door lock assembly LH.
69140 21.REMOVE REAR DOOR LOCK ACTUATOR ASSEMBLY LH (w/ Power Door Lock)
Remove the 2 screws.
Detach the guide and rear door lock actuator assembly LH in the direction indicated by the arrow in the illustration.