Home › Vehicle Exterior › DOOR / HATCH › REAR DOOR › from 2022.09
RM25T0E _59 Vehicle Exterior _029937 DOOR / HATCH _0137852 REAR DOOR A

DOOR / HATCH  REAR DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 69206C 3.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

a.
B385079C02
0,0 0,0 false
V100135

Screw
V100136

Forward


Remove the screw.


b.

Detach the 4 guides in the direction indicated by the arrow in the illustration.


c.
B167866

Disconnect the rear door inside handle sub-assembly LH from the control link and remove the rear door inside handle sub-assembly LH.


Hide 69260E 4.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

a.
B382328

Insert a clip remover between the plate and trim.


b.

Turn the handle clockwise to remove the snap ring. Then remove the rear door window regulator handle assembly.


Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

a.
B381938

Using moulding remover B, detach the clip and 3 claws, and remove the rear power window regulator switch assembly with rear door armrest base panel.


b.

Disconnect the connector.


Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Power Window)

a.
B381939

Remove the 2 caps and 2 screws.


b.

Detach the 16 clips and remove the rear door trim board sub-assembly LH.


Hide 74240 7.REMOVE REAR ARMREST ASSEMBLY LH (w/ Power Window)

a.
B381940

Remove the 4 screws and rear armrest assembly LH.


Hide 74240 8.REMOVE REAR ARMREST ASSEMBLY LH (w/o Power Window)

a.
B171841

Remove the 2 screws and rear armrest assembly LH.


Hide 67604 9.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/o Power Window)

a.
B167886

Detach the 16 clips and remove the rear door trim board sub-assembly LH.


Hide 69759J 10.REMOVE DOOR LOCK LINK SILENCER

a.

Remove the door lock link silencer.


Hide 67842E 11.REMOVE REAR DOOR SERVICE HOLE COVER LH

a.
B381941

Using a clip remover, remove the 2 grommets and 2 clamps.


b.

Remove the rear door service hole cover LH.

HINT:

Remove the remaining tape on the door.



Hide 69780A 12.REMOVE REAR DOOR INSIDE LOCKING LINK ASSEMBLY LH

a.

Remove the bolt, knob and knob holder.


b.
B167872

Detach the snap and rear door inside locking link assembly LH.


Hide 69718B 13.REMOVE REAR DOOR LOCK REMOTE CONTROL LINK LH

a.
B168636

Detach the snap and rear door lock remote control link LH as shown in the illustration.


Hide 68142 14.REMOVE REAR DOOR GLASS RUN

a.

w/o Power Window:

i.

Temporarily install the window regulator handle.


ii.

Move the rear door glass sub-assembly so that the door glass channel can be seen.


iii.

Remove the window regulator handle.



b.

w/ Power Window:

i.

Temporarily install the rear power window regulator switch assembly.


ii.

Connect the cable to the negative (-) battery terminal.


iii.

Move the rear door glass sub-assembly so that the door glass channel can be seen.


iv.

Disconnect the cable from the negative (-) battery terminal.


v.

Remove the rear power window regulator switch assembly.



c.
B167873

Remove the rear door glass run.


Hide 67408E 15.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

a.
B113149

Lift up the weatherstrip and remove the screw.


b.

Remove the 2 bolts and rear door window division bar sub-assembly LH.


Hide 68104 16.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

a.
B385059

Remove the 2 nuts.

NOTICE:

Be careful when removing the bolts as the glass may fall and become damaged.



b.

Remove the rear door glass sub-assembly LH.

NOTICE:

Be careful not to damage the glass.



Hide 68240A 17.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP ASSEMBLY LH

a.
B167871

Detach the 4 claws and remove the rear door inner glass weatherstrip assembly LH.


Hide 62714 18.REMOVE REAR QUARTER WINDOW GLASS LH

B382364

a.

Remove the rear quarter window glass LH with the rear door quarter window weatherstrip LH.


Hide 68189 19.REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP LH

B382365

a.

Remove the rear door quarter window weatherstrip LH.


Hide 69804 20.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/ Power Window)

a.

Disconnect the connector.


b.
B382330C02
2,0.708 2,0.458 2,0.458 1.719,0.458 true 1.542,0.365 1.76,0.573 0.219,0.208 10 true *1
*1 Temporary Bolt


Loosen the temporary bolt.

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator sub-assembly LH may fall and become damaged.



c.

Remove the 3 bolts and rear door window regulator sub-assembly LH.


d.

Remove the temporary bolt from the rear door window regulator sub-assembly LH.


Hide 85720B 21.REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (w/ Power Window)

Hide 69804 22.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/o Power Window)

a.
B167880

Remove the 3 bolts and rear door window regulator sub-assembly LH.


Hide 68230C 23.REMOVE REAR DOOR OUTER GLASS WEATHESTRIP ASSEMBLY LH

Hide 67836 24.REMOVE REAR DOOR LOCK CHILD PROTECTION COVER

a.

Remove the rear door lock child protection cover.


Hide 69340 25.REMOVE REAR DOOR LOCK ASSEMBLY LH

Hide 69140 26.REMOVE REAR DOOR LOCK ACTUATOR ASSEMBLY LH (w/ Power Door Lock)

Hide 69240 27.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B167878

Remove the 2 bolts and rear door outside handle assembly LH.


Hide 68630 28.REMOVE REAR DOOR CHECK ASSEMBLY

a.
B168410

Using a hammer, tap out the door check pin.


b.

Remove the 2 bolts and rear door check assembly.

NOTICE:

Be careful when removing the bolts as the door check may fall and become damaged.



Hide 67872 29.REMOVE REAR DOOR WEATHERSTRIP LH

a.
B167870

Using a clip remover, detach the 18 clips and remove the rear door weatherstrip.

HINT:

If any clips are damaged, replace them.



Hide 30.REMOVE CUSHION

a.

Remove the cushion.