Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
69140 1.INSTALL REAR DOOR LOCK ACTUATOR ASSEMBLY LH (w/ Power Door Lock)
Attach the guide in the direction indicated by the arrow in the illustration.
Install the rear door lock actuator assembly LH to the rear door lock assembly LH with the 2 screws.
69340 2.INSTALL REAR DOOR LOCK ASSEMBLY LH
Apply MP grease to the sliding parts of the rear door lock assembly LH.
Insert the rear door lock assembly LH into the rear door outside handle release plate, and set it on the rear door panel.
Check that the rear door outside handle release plate is securely connected to the rear door lock assembly.
Using a T30 "TORX" socket wrench, install the rear door lock assembly LH with the 3 screws.
Connect the connector.
Install the bolt.
Attach the clamp.
67836 3.INSTALL REAR DOOR LOCK CHILD PROTECTION COVER
69804 4.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/ Power Window)
69804 5.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/o Power Window)
68240A 6.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP ASSEMBLY LH
68104 7.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
67408E 8.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68142 9.INSTALL REAR DOOR GLASS RUN
69718B 10.INSTALL REAR DOOR LOCK REMOTE CONTROL LINK LH
69780A 11.INSTALL REAR DOOR INSIDE LOCKING LINK ASSEMBLY LH
67842E 12.INSTALL REAR DOOR SERVICE HOLE COVER LH
69759J 13.INSTALL DOOR LOCK LINK SILENCER
67604 14.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/o Power Window)
74240 15.INSTALL REAR ARMREST ASSEMBLY LH (w/o Power Window)
67604 16.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Power Window)
17.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
69260E 18.INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
69206C 19.INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH
20.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
21. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
22.CHECK POWER WINDOW CONTROL SYSTEM (w/ Power Window)
23.CHECK POWER DOOR LOCK CONTROL SYSTEM (w/ Power Door Lock)