Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
45130 1.INSTALL STEERING PAD
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *a | Connector Lock |
Support the steering pad with one hand.
Connect the horn connector.
Connect the airbag connector and lock the connector lock.
When handling the airbag connector, take care not to damage the airbag wire harness.
Set the steering pad to the steering wheel assembly.
Check that the airbag wire harness and horn wire harness are not pinched.
| *a | Upper Pin |
| *b | Lower Pin |
Press the steering pad with both hands to attach the upper pin to the torsion spring.
Press the steering pad with both hands to attach the lower pin to the torsion spring.
After installation, try to pull the steering pad and check that the steering pad is securely installed.
45187 2.INSTALL LOWER NO. 3 STEERING WHEEL COVER
Attach the guide and claw to install the lower No. 3 steering wheel cover.
45186 3.INSTALL LOWER NO. 2 STEERING WHEEL COVER
Attach the guide and claw to install the lower No. 2 steering wheel cover.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
45130 6.INSPECT STEERING PAD
With the steering pad installed to the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
Click hereVehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE
7.PERFORM DIAGNOSTIC SYSTEM CHECK
8.CHECK SRS WARNING LIGHT