Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › from 2022.09
RM25T0E _58 Vehicle Interior _029929 SUPPLEMENTAL RESTRAINT SYSTEMS _0138000 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 82143 1.INSTALL NO. 3 INSTRUMENT PANEL WIRE

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.


a.
B374346C01
2.375,0.99 2.375,0.771 2.375,0.771 2.74,0.573 true 2.323,1.042 2.635,1.198 0.313,0.156 10 false *1
*1 Connector Lock


Attach the wire harness clamp to install the No. 3 instrument panel wire.


b.

Connect the airbag connector and lock the connector lock.


Hide 73970A 2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Attach the wire harness clamp.


d.

Attach the 2 guides and 14 claws to install the instrument panel passenger airbag assembly.


e.

Install the 2 bolts.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


f.
B374343C01
1.76,2.604 1.688,2.313 1.688,2.313 1.375,2.313 true 2.729,2.594 2.656,2.302 2.656,2.302 2.344,2.302 true 1.208,2.208 1.521,2.365 0.313,0.156 10 false *1 2.156,2.188 2.469,2.344 0.313,0.156 10 false *a
*1 Slider
*a Lock Position


Connect the airbag connector and check that the slider is in the lock position.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.


HINT:

If the slider is not in the lock position, the airbag connector is not completely connected. Disconnect the airbag connector, check the airbag connector and instrument panel wire terminals and connector housings for deformation or foreign matter, and then reconnect the airbag connector.



Hide 55433B 3.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

a.

Attach the 2 guides.


b.

Attach the 3 claws to install the lower No. 2 instrument panel finish panel.


Hide 55550 4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART