89170 1.INSTALL CENTER AIRBAG SENSOR ASSEMBLY
Temporarily install the center airbag sensor assembly to the airbag sensor bracket with the 3 bolts.
Tighten the 3 bolts order shown in the illustration.
89175 2.INSTALL AIRBAG SENSOR BRACKET
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Check that the waterproof sheet is properly set.
Temporarily install the airbag sensor bracket with the 3 bolts.
If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace airbag sensor assembly with a new one.
When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
| *a | Connector Lock |
| *b | Waterproof Sheet |
Tighten the 3 bolts order shown in the illustration.
Connect the airbag connector and push the connector lock to lock the airbag connector.
When handling any airbag connector, take care not to damage the airbag wire harness.
Do not allow the water proof sheet to become pinched.
Check that there is no looseness in the installation parts of the center airbag sensor assembly.
89179A 3.INSTALL AIRBAG SENSOR COVER
Temporarily install the airbag sensor cover with the 3 bolts.
Tighten the 3 bolts order shown in the illustration.
58811B 4.INSTALL CONSOLE BOX
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
7.PERFORM DIAGNOSTIC SYSTEM CHECK
8.CHECK SRS WARNING LIGHT
9. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION (w/ VSC)
When the center airbag sensor assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor.
The yaw rate and acceleration sensor is built into the airbag ECU assembly.