Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
89174A 1.INSTALL FRONT AIRBAG SENSOR LH
Check that the ignition switch is off.
Check that the cable is disconnected from the battery negative (-) terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
w/o Curtain Shield Airbag
Attach the guide and hold the front airbag sensor LH in place.
Install the nut.
If the front airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the front airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Tighten the nut while holding the front airbag sensor LH because the front airbag sensor LH guide is easily damaged.
w/ Curtain Shield Airbag
Attach the guide and hold the front airbag sensor LH in place.
Install the bolt.
If the front airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the front airbag sensor LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Tighten the bolt while holding the front airbag sensor LH because the front airbag sensor LH guide is easily damaged.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.
| *a | Incorrect | *b | Correct |
While holding the CPA be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).
When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and upper part of the CPA, as it may result in an insecure fit.
| *a | Housing Lock | *b | CPA |
| *c | CPA Upper Part | *d | Connection is Completed |
Check that there is no looseness in the installation parts of the front airbag sensor LH.
2.INSTALL HEADLIGHT ASSEMBLY LH (w/ Curtain Shield Airbag)
53111 3.INSTALL RADIATOR GRILLE
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>INSTALLATION
for Step Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Step Type)>INSTALLATION
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6.PERFORM DIAGNOSTIC SYSTEM CHECK
7.CHECK SRS WARNING LIGHT