Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)
74640C 3.REMOVE DOOR ASSIST GRIP ASSEMBLY LH (w/ Assist Grip)
69206B 4.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
68278B 5.REMOVE DOOR INSIDE HANDLE BEZEL (w/ Double Inside Handles)
6.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side, w/Power Window)
7.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side, w/Power Window)
69260 8.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
67602 9.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Armrest)
67702 10.REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Canvas Top)
67602 11.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Canvas Top)
69759V 12.REMOVE FRONT DOOR LOCK LINK SILENCER
69205 13.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY RH (w/ Double Inside Handles)
67832 14.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68220A 15.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP ASSEMBLY LH
68141 16.REMOVE FRONT DOOR GLASS RUN
68102 17.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH (w/ Power Window)
68102 18.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH (w/o Power Window)
68210C 19.REMOVE FRONT DOOR OUTER GLASS WEATHERSTRIP ASSEMBLY LH
Put protective tape around the front door outer glass weatherstrip assembly LH.
w/o Vent Window:
| *1 | Protective Tape |
Detach the 7 claws and remove the front door outer glass weatherstrip assembly LH.
w/ Vent Window:
| *1 | Protective Tape |
Detach the 5 claws and remove the front door outer glass weatherstrip assembly LH.
for Model Code #J76 Series, for Double Cab:
| *1 | Protective tape |
Detach the 6 claws and remove the front door outer glass weatherstrip assembly LH.