Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
87940 3.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
87941 4.REMOVE OUTER REAR VIEW MIRROR GASKET LH
5.REMOVE HOLE PLUG (for Canvas Top)
Remove the 4 hole plugs.
74640C 6.REMOVE DOOR ASSIST GRIP ASSEMBLY LH (w/ Assist Grip)
Detach the 4 claws and remove the 2 caps.
Remove the 2 screws and door assist grip assembly LH.
69206B 7.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
|
Screw |
|
Forward |
Remove the screw.
Detach the 4 guides in the direction indicated by the arrow in the illustration.
| *A | Type A |
| *B | Type B |
Disconnect the front door inside handle sub-assembly LH from the control link and remove the front door inside handle sub-assembly LH.
68278B 8.REMOVE DOOR INSIDE HANDLE BEZEL (w/ Double Inside Handles)
Remove the screw and door inside handle bezel.
9.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side, w/ Power Window)
| *A | Type A |
| *B | Type B |
Using moulding remover B, detach the clip and 4 claws, and remove the power window regulator master switch assembly with front door armrest base panel.
Disconnect the connector.
10.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side, w/ Power Window)
w/o Double Inside Handles:
Using moulding remover B, detach the clip and 4 claws, and remove the power window regulator switch assembly with front door armrest base panel.
w/ Double Inside Handles:
Using moulding remover B, detach the 2 claws and remove the power window regulator switch assembly with front door armrest base panel.
Disconnect the connector.
69260 11.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
Insert a clip remover between the plate and trim.
Turn the handle clockwise to remove the snap ring. Then remove the front door window regulator handle assembly.
67602 12.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Armrest)
w/ Power Window:
Remove the 2 caps and 2 screws.
w/o Power Window:
Remove the 2 screws and front armrest assembly LH.
Detach the 14 clips and remove the front door trim board sub-assembly LH.
67702 13.REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Canvas Top)
Remove the screw.
Detach the guide and remove the front door trim cover sub-assembly LH.
67602 14.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Canvas Top)
Detach the 14 clips and front door trim board sub-assembly LH.
74220 15.REMOVE FRONT ARMREST ASSEMBLY LH (w/ Armrest, w/ Power Window)
Remove the 5 screws and front armrest assembly LH.
74231 16.REMOVE FRONT ARMREST UPPER BASE PANEL (w/ Double Inside Handles)
Remove the 4 screws and front armrest upper base panel.
67778 17.REMOVE FRONT DOOR TRIM POCKET LH (w/ Door Pocket)
Remove the 5 screws and front door trim pocket LH.
69759V 18.REMOVE FRONT DOOR LOCK LINK SILENCER
Remove the front door lock link silencer.
69205 19.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY RH (w/ Double Inside Handles)
Remove the 2 screws.
Disconnect the front door inside handle sub-assembly RH from the control link and remove the front door inside handle sub-assembly RH.
67832 20.REMOVE FRONT DOOR SERVICE HOLE COVER LH
Using a clip remover, detach the clamp and remove the 2 grommets.
Remove the front door service hole cover LH.
Remove the remaining tape on the door.
68220A 21.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP ASSEMBLY LH
w/ Vent Window:
Detach the 5 claws and remove the front door inner glass weatherstrip assembly LH.
w/o Vent Window:
Detach the 7 claws and remove the front door inner glass weatherstrip assembly LH.
for Model Code #J76 Series, for Double Cab:
Detach the 6 claws and remove the front door inner glass weatherstrip assembly LH.
68141 22.REMOVE FRONT DOOR GLASS RUN
w/o Power Window:
Temporarily install the window regulator handle.
Move the rear door glass sub-assembly so that the door glass channel can be seen.
Remove the window regulator handle.
w/ Power Window:
Temporarily install the rear power window regulator switch assembly.
Connect the cable to the negative (-) battery terminal.
Move the rear door glass sub-assembly so that the door glass channel can be seen.
Disconnect the cable from the negative (-) battery terminal.
Remove the rear power window regulator switch assembly.
Remove the front door glass run.
68102 23.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH (w/ Power Window)
w/ Vent Window:
Remove the front door glass sub-assembly LH from the front door window regulator assembly as shown in the illustration.
Remove the front door glass sub-assembly LH as indicated by the arrows in the order shown in the illustration.
Be careful not to damage the glass.
w/o Vent Window:
Remove the 2 bolts.
Be careful when removing the bolts as the glass may fall and become damaged.
Remove the front door glass sub-assembly LH as indicated by the arrows in the order shown in the illustration.
Be careful not to damage the glass.
68102 24.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH (w/o Power Window)
w/ Vent Window:
Remove the front door glass sub-assembly LH from the front door window regulator assembly as shown in the illustration.
Remove the front door glass sub-assembly LH as indicated by the arrows in the order shown in the illustration.
Be careful not to damage the glass.
w/o Vent Window:
Remove the 2 bolts.
Be careful when removing the bolts as the glass may fall and become damaged.
Remove the front door glass sub-assembly LH as indicated by the arrows in the order shown in the illustration.
Be careful not to damage the glass.
69802 25.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/ Power Window)
| *A | w/o Vent Window |
| *B | w/ Vent Window |
| *1 | Temporary Bolt |
Disconnect the connector.
Loosen the temporary bolt.
Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and cause damage.
w/o Vent Window:
Remove the 5 bolts.
w/ Vent Window:
Remove the 3 bolts.
Remove the front door window regulator sub-assembly LH
Remove the temporary bolt from the front door window regulator sub-assembly LH.
85720A 26.REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (w/ Power Window)
69802 27.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH (w/o Power Window)
| *A | w/o Vent Window |
| *B | w/ Vent Window |
w/o Vent Window:
Remove the 5 bolts.
w/ Vent Window:
Remove the 3 bolts.
68210C 28.REMOVE FRONT DOOR OUTER GLASS WEATHERSTRIP ASSEMBLY LH
67862 29.REMOVE FRONT DOOR WEATHERSTRIP LH (for Canvas Top)
Remove the 2 screws and front door weatherstrip LH.
67864B 30.REMOVE FRONT DOOR NO. 2 WEATHERSTRIP LH (for Canvas Top)
Using a clip remover, detach the 22 clips and remove the front door weatherstrip LH.
If any clips are damaged, replace them.
68193C 31.REMOVE FRONT DOOR FRONT BELT SEAL LH (for Canvas Top)
Remove the screw and front door front belt seal LH.
67042 32.REMOVE FRONT DOOR WINDOW FRAME SUB-ASSEMBLY LH (for Canvas Top)
Remove the 5 bolts and front door window frame sub-assembly LH.
67402F 33.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH (for Canvas Top)
Remove the 2 bolts and front door front lower frame sub-assembly LH.
67402F 34.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH (w/o Vent Window, except Canvas Top)
|
Bolt |
|
Screw |
Lift up the weatherstrip and remove the 2 screws.
Remove the 2 bolts.
|
Detaching Direction |
Remove the front door front lower frame sub-assembly LH in the direction indicated by the arrow in the illustration.
67482A 35.REMOVE FRONT DOOR FRONT LOWER FRAME SEAL LH (w/o Vent Window, except Canvas Top)
Remove the front door front lower frame seal LH from the front door front lower frame sub-assembly LH.
68142A 36.REMOVE FRONT DOOR SIDE GLASS RUN (for Canvas Top)
Remove the front door side glass run.
67504A 37.REMOVE FRONT DOOR DIVISION BAR SUB-ASSEMBLY LH (w/ Vent Window)
Remove the bolt and 3 screws.
Remove the front door division bar sub-assembly LH as indicated by the arrows in the order shown in the illustration.
67404F 38.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH (for Canvas Top)
Remove the 2 bolts and the front door rear lower frame sub-assembly LH.
67404F 39.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH (except Canvas Top)
Detach the guide and remove the bolt, and front door rear lower frame sub-assembly LH.
68143A 40.REMOVE FRONT DOOR NO. 2 GLASS RUN (w/o Vent Window)
Remove the front door No. 2 glass run from the front door front lower frame sub-assembly LH.
69712A 41.REMOVE FRONT DOOR LOCK REMOTE CONTROL LINK LH
Remove the front door lock remote control link LH from the front door lock assembly as shown in the illustration.
69604A 42.REMOVE FRONT DOOR LOCK REMOTE CONTROL ROD SUB-ASSEMBLY LH
Remove the front door lock remote control rod sub-assembly LH as shown in the illustration.
Detach the 2 claws and remove the holder.
69052 43.REMOVE FRONT DOOR LOCK CYLINDER ASSEMBLY LH
Detach the snap from the front door lock cylinder assembly LH as shown in the illustration.
Remove the plate.
Remove the front door lock cylinder assembly LH.
69220 44.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
Detach the snap and disconnect the control link from the front door outside handle assembly LH as shown in the illustration.
The control link can be easily removed by pushing the end of the control link with the tip side of a screwdriver.
Remove the 2 bolts and front door outside handle assembly LH.
69320 45.REMOVE FRONT DOOR LOCK ASSEMBLY LH
69310 46.REMOVE FRONT DOOR LOCK ASSEMBLY RH (w/ Double Inside Handles)
69120A 47.REMOVE FRONT DOOR LOCK ACTUATOR ASSEMBLY LH (w/ Power Door Lock, Type B)
68610 48.REMOVE FRONT DOOR CHECK ASSEMBLY
Using a hammer, tap out the front door check pin.
Remove the 2 bolts and front door check assembly.
Be careful when removing the bolts as the door check may fall and become damaged.
67862 49.REMOVE FRONT DOOR WEATHERSTRIP LH (except Canvas Top)
Using a clip remover, detach the 22 clips and remove the front door weatherstrip LH.
If any clips are damaged, replace them.