Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU › from 2022.09
RM25T0E _57 Power Source / Network _057931 NETWORKING _0548835 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



Hide 55550 3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55433B 4.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 5.REMOVE NETWORK GATEWAY ECU

a.
B649993C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


Remove the bolt.


b.

Detach the hook and remove the network gateway ECU.


c.

Disconnect the connector.