Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  C052696  Steering Angle Sensor Module Component Internal Failure  


DESCRIPTION

The skid control ECU (brake actuator assembly) outputs this DTC when it receives an internal malfunction signal from the steering sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area
C052696 Steering Angle Sensor Module Component Internal Failure With the +BS terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering sensor. Steering sensor (Spiral cable with sensor sub-assembly)

PROCEDURE

1.REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
a.

Replace the steering sensor (spiral cable with sensor sub-assembly).

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR (w/ VSC)>REMOVAL

NOTICE:

When replacing the steering sensor (spiral cable with sensor sub-assembly), confirm that the replacement part is of the correct specification.


HINT:

If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>PROBLEM SYMPTOMS TABLE



Result:
Proceed to
NEXT



NEXT

END