Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  Zero Point Calibration of Steering Angle Sensor Malfunction (X20D7)  


DESCRIPTION

Code Tester Display Measurement Item Trouble Area
X20D7 Zero Point Calibration of Steering Angle Sensor Malfunction History of the steering sensor zero point calibration position differing from the stored value
·

Poor adjustment of the center position of the steering wheel

·

Poor adjustment of wheel alignment



CAUTION / NOTICE / HINT

NOTICE:

After performing the inspection, check and clear the vehicle control history.


PROCEDURE

1.CHECK FOR DTCs (HEALTH CHECK)
a.

Using the GTS, perform the Health Check.


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.CLEAR VEHICLE CONTROL HISTORY

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

2.CLEAR VEHICLE CONTROL HISTORY
a.

Using the GTS, clear the Vehicle Control History.

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55

Result:
Proceed to
NEXT



NEXT

3.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
3.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
a.

Perform zero point calibration of the yaw rate and acceleration sensor.

Chassis > Brake > Utility
Tester Display
Reset Memory
50005 435 4560
Chassis > Brake > Utility
Tester Display
Calibration
50005 435 4554

Result:
Proceed to
NEXT



NEXT

4.CHECK STEERING SENSOR ZERO POINT CALIBRATION
4.CHECK STEERING SENSOR ZERO POINT CALIBRATION
a.

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.


b.

Drive the vehicle straight ahead at 15 km/h (9 mph) or more for at least 60 seconds.


c.

Check that the centered position of the steering wheel is correctly set while driving straight ahead.

Standard:

The steering wheel is centered correctly.



Result:
Proceed to
OK
NG



OK

5.INSPECT STEERING SYSTEM

NG

7.ADJUST WHEEL ALIGNMENT
5.INSPECT STEERING SYSTEM
a.

Perform the steering system on-vehicle inspection.

Click hereSteering>STEERING COLUMN>STEERING SYSTEM>ON-VEHICLE INSPECTION


Result:
Proceed to
OK
NG



OK

NG

6.REPAIR OR REPLACE MALFUNCTIONING PART
6.REPAIR OR REPLACE MALFUNCTIONING PART
Result:
Proceed to
NEXT



NEXT

8.CLEAR VEHICLE CONTROL HISTORY
7.ADJUST WHEEL ALIGNMENT
a.

Adjust the alignment (toe) of the wheels.

Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT>ADJUSTMENT


Result:
Proceed to
NEXT



NEXT

8.CLEAR VEHICLE CONTROL HISTORY
8.CLEAR VEHICLE CONTROL HISTORY
a.

Using the GTS, clear the Vehicle Control History.

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55

Result:
Proceed to
NEXT



NEXT

9.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
9.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR
a.

Perform zero point calibration of the yaw rate and acceleration sensor.

Chassis > Brake > Utility
Tester Display
Reset Memory
50005 435 4560
Chassis > Brake > Utility
Tester Display
Calibration
50005 435 4554

Result:
Proceed to
NEXT



NEXT

10.PERFORM ZERO POINT CALIBRATION OF STEERING SENSOR
10.PERFORM ZERO POINT CALIBRATION OF STEERING SENSOR
a.

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.


b.

Drive the vehicle straight ahead at 15 km/h (9 mph) or more for at least 60 seconds.


Result:
Proceed to
NEXT



NEXT

11.CHECK VEHICLE CONTROL HISTORY
11.CHECK VEHICLE CONTROL HISTORY
a.

Perform a road test under the same malfunction conditions recreated based on the Freeze Frame Data or customer problem analysis.


b.

Using the GTS, check for Vehicle Control History.

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55

Result:
Result Proceed to
Vehicle Control History is not output A
Vehicle Control History is output B



A

END

B