Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  VEHICLE CONTROL HISTORY (RoB)  


DESCRIPTION


·

Vehicle Control History is a function that captures and stores ECU data when triggered by specific vehicle behavior.

·

It may be possible to determine the cause of the malfunction by checking the vehicle history information and freeze frame data.

·

The number of possible stored Freeze Frame Data sets, whether multi Freeze Frame Data is available, the number of freeze frame points, Freeze Frame Data items, the ECU internal range, etc., is different depending on the stored group.

·

The stored data items for Vehicle Control History Freeze Frame Data are different depending on the stored group. When the value of a data item does not change across all points, only the value of the detection point will be displayed. The content of the Freeze Frame Data is almost the same as that of the Data List.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System)>DATA LIST / ACTIVE TEST



PRECAUTIONS


·

As Vehicle Control History may be overwritten whenever the trigger conditions are met, make sure to save Vehicle Control History before performing any inspections.

·

As Vehicle Control History may be stored when performing an Active Test, learning, etc., make sure to clear the Vehicle Control History before returning the vehicle to the customer.



CHECK VEHICLE CONTROL HISTORY (VEHICLE STABILITY CONTROL SYSTEM)


a.

Operate the GTS to enter the Vehicle Control History (RoB).

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55
Vehicle Control History Item
Code Tester Display Measurement Item User Notification Diagnostic Note
X204C Zero Point Calibration of Yaw Rate Sensor Undone History of incomplete yaw rate sensor zero point calibration Slip indicator light illuminates (Click here)
X2079 Communication Error from Brake Control Module to Engine Control Module History of being unable to send data to the ECM continuously for 2 seconds or more Slip indicator light illuminates
1.

Using the GTS, perform a Health Check.

2.

Refer to the flowchart(s) for the output DTCs.


X2087 Engine Malfunction History of receiving an engine control system malfunction signal continuously from the ECM for 1 second or more Slip indicator light illuminates for 1VD-FTV:(Click here)
for 1VD-FTV (w/ DPF):(Click here)
for 1VD-FTV (w/o EGR System):(Click here)
X2088 Bank Angle Detected History of VSC operation being temporarily prohibited when driving at a steep bank angle, etc. Slip indicator light illuminates Explain that VSC operation was temporarily prohibited when driving on a road with a steep bank angle, etc.
X208A Zero Point Calibration of Steering Angle Sensor Initialization Malfunction History of being unable to obtain the steering zero point after driving at a vehicle speed exceeding 15 km/h (9 mph) for 0.05 seconds or more Slip indicator light illuminates Perform steering sensor zero point calibration.
X2096 Pre-Collision Brake History of pre-collision brake operation In accordance with Pre-collision System behavior -
X2098 Pre-Collision Brake Assist History of pre-collision brake assist operation In accordance with Pre-collision System behavior -
X20A0 ABS History of ABS operation - -
X20A1 VSC History of VSC operation Slip indicator light blinks -
X20A5 Hill Start Assist History of hill start assist operation - -
X20A7 Brake Assist History of brake assist operation - -
X20D7 Zero Point Calibration of Steering Angle Sensor Malfunction History of the steering sensor zero point calibration position differing from the stored value Slip indicator light illuminates (Click here)
X20D8 Zero Point Calibration of Steering Angle Sensor Not Acquired History of being unable to obtain the steering angle zero point Slip indicator light illuminates (Click here)
X215A Rear Differential Lock Malfunction History of a malfunction in the rear differential lock
·

ABS warning light illuminates

·

Slip indicator light illuminates


-



CLEAR VEHICLE CONTROL HISTORY (VEHICLE STABILITY CONTROL SYSTEM)


a.

Operate the GTS to enter the Vehicle Control History (RoB).

Chassis > Brake > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 55

b.

Press the DTC clear button.

NOTICE:

By performing this procedure, all stored Vehicle Control History items will be cleared.




CHECK VEHICLE CONTROL HISTORY (AIRBAG SYSTEM)


HINT:

A part of the control history can be confirmed using the vehicle control history.