The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake actuator assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
4.REMOVE BRAKE ACTUATOR WITH BRACKET
Place tags or marks to identify the installation locations of each brake line.
| *A | for LHD | *B | for RHD |
| *a | To Front Wheel Cylinder RH | *b | To Front Wheel Cylinder LH |
| *c | To Rear Wheel Cylinder RH | *d | To Rear Wheel Cylinder LH |
| *e | From 1st Chamber of Brake Master Cylinder Sub-assembly | *f | From 2nd Chamber of Brake Master Cylinder Sub-assembly |
Release the lock lever and disconnect the connector from the brake actuator assembly.
| *A | for LHD | *B | for RHD |
|
Lock Lever Released |
|
Connector Disconnected |
Be careful not to allow any brake fluid to enter the connector.
Detach the 3 clamps from the brake actuator bracket assembly.
Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.
| *A | for LHD | *B | for RHD |
Remove the 3 nuts and brake actuator with bracket.
Do not damage the brake lines.
44510 5.REMOVE BRAKE ACTUATOR ASSEMBLY
Remove the 3 bolts and brake actuator assembly from the brake actuator bracket.
6.REMOVE BRAKE ACTUATOR CASE COLLAR
Remove the 3 brake actuator case collars from the 3 brake actuator bracket cushions.
44547B 7.REMOVE BRAKE ACTUATOR BRACKET CUSHION
Remove the 3 brake actuator bracket cushions from the brake actuator bracket.