1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.REMOVE REAR NO. 2 SIDE SEAT ASSEMBLY LH
67918A 4.REMOVE REAR DOOR SCUFF PLATE LH
62552F 5.REMOVE REAR SEAT SIDE GARNISH LH
64707D 6.REMOVE QUARTER TRIM JACK COVER SUB-ASSEMBLY
62640P 7.REMOVE QUARTER TRIM PANEL ASSEMBLY LH
8.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER
Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
Remove the bolt.
Detach the 2 guides to remove the tire pressure warning ECU and receiver.
Disconnect the connector from the tire pressure warning ECU and receiver.