27020 1.INSTALL GENERATOR ASSEMBLY
Set the generator assembly with the 2 stud bolts.
Using an E7 "TORX" socket wrench, tighten the 2 stud bolts.
Install the generator assembly with the 2 nuts and 3 bolts in the order shown in the illustration.
Connect the generator connector.
Connect the generator wire with the nut.
Install the terminal cap.
27280 2.INSTALL GENERATOR SPLASH GUARD COVER ASSEMBLY
Install the generator splash guard cover assembly with the 3 bolts.
Temporarily install all of the bolts, and then tighten the bolts to the specified torque.
Connect the wire harness clamp to the generator splash guard cover assembly.
16361A 3.INSTALL FAN AND GENERATOR V BELT
51442 4.INSTALL NO. 2 ENGINE UNDER COVER
28800 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART