Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  ABS Operates Before Necessary When Braking  


DESCRIPTION

Troubleshooting for when ABS operates too soon due to a noisy signal from the speed sensor, a difference in output, etc.

PROCEDURE

1.PERFORM DEALER MODE (SIGNAL CHECK) INSPECTION (SPEED SENSOR CHECK)
a.

Using the GTS, perform a Dealer Mode (Signal Check) inspection sensor check and check that speed sensor Dealer Mode (Signal Check) inspection items change from incomplete to complete.

Chassis > Brake/EPB > Utility
Tester Display
Signal Check
50005 435 4558
OK:

Speed sensor Dealer Mode (Signal Check) inspection items change from incomplete to complete.


Result:
Result Proceed to
OK (for Front) A
OK (for Rear) B
NG C


NOTICE:
·

When cleaning the front speed sensor, make sure to clean the installation hole before installation.

·

Do not use parts cleaner when cleaning the front speed sensor rotor.



HINT:

The rear speed sensor and rear speed sensor rotor are incorporated into the rear axle hub and bearing assembly.

If the rear speed sensor and rear speed sensor rotor need to be replaced, replace the rear axle hub and bearing assembly.




A

CLEAN SPEED SENSOR AND SPEED SENSOR ROTOR

B

REPLACE REAR AXLE HUB AND BEARING ASSEMBLY

C

INSPECT AND REPAIR MALFUNCTIONING SPEED SENSOR CIRCUIT