| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | WIPER RUBBER LH | 85214B | ( )
|
- | - |
| 2 | FRONT WIPER BLADE LH | 85222A | - | - | - |
| 3 | RETURN NORMAL POSITION | - | - | - | ( )
|
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
85214B
1.INSTALL WIPER RUBBER LH
Install the 2 front wiper rubber backing plates to the wiper rubber LH as shown in the illustration.
Align the protrusions on the wiper rubber LH and the notches of the front wiper rubber backing plates.
Install the wiper rubber LH together with the 2 front wiper rubber backing plates to the front wiper blade LH.
Install the wiper rubber LH so that the head part (the wide side) faces the arm axis direction.
Push the front wiper blade LH to the groove of the wiper rubber RH end to attach it completely.
85222A
2.INSTALL FRONT WIPER BLADE LH
3. RETURN NORMAL POSITION
Turn the ignition switch on.
Operate the wiper switch to the MIST direction.
Check that the front wiper arm LH is not in the locked back position.
If the front wiper arm LH is operated while left in the locked back position, the vehicle may be damaged.