| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( )
|
- | - |
| 2 | ROOF HEADLINING ASSEMBLY | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | TELEPHONE ANTENNA ASSEMBLY WITH COVER | - | - | - | - |
| 4 | TELEPHONE ANTENNA ASSEMBLY | 86760A | - | - | - |
| *1 | ANTENNA COVER | *2 | ROOF ANTENNA HOUSING |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the telephone antenna assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
2.REMOVE ROOF HEADLINING ASSEMBLY
3.REMOVE TELEPHONE ANTENNA ASSEMBLY WITH COVER
|
Remove in this Direction | - | - |
86760A
4.REMOVE TELEPHONE ANTENNA ASSEMBLY
| *A | When reusing the telephone antenna assembly | - | - |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |