Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY
RM37H0E _58 Vehicle Interior _095292 SEAT _0448102 REAR SEAT ASSEMBLY A

SEAT  REAR SEAT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B591337N07
0.729,5.365 0.729,4.781 false 0.51,5.365 1.74,5.365 false 3.396,5.031 2.844,5.031 false 1.833,2.729 1.51,2.729 false 5.823,3.333 5.271,3.333 false 2.813,3.667 2.49,3.667 false 5.958,5.167 5.635,5.167 false 4.531,0.24 4.292,0.24 4.292,0.24 4.292,0.448 false 5.615,0.802 5.375,0.802 5.375,0.802 5.375,1.01 false 6.583,1.302 6.344,1.302 6.344,1.302 6.344,1.51 false 4.229,1.167 4.229,0.979 false 5.302,1.729 5.302,1.542 false 6.292,2.198 6.292,2.042 false 0.24,5.208 0.49,5.521 0.25,0.313 18 false 2 0.052,5.292 0.208,5.49 0.156,0.198 10 false ● 3.729,4.896 3.979,5.208 0.25,0.313 18 false 1 6.146,3.208 6.396,3.521 0.25,0.313 18 false 3 6,5.073 6.313,5.271 0.313,0.198 10 false *1 1.865,2.635 2.177,2.833 0.313,0.198 10 false *2 2.854,3.583 3.167,3.781 0.313,0.198 10 false *3 4.573,0.167 4.729,0.365 0.156,0.198 10 false ● 4.771,0.083 5.021,0.396 0.25,0.313 18 false 4 5.656,0.719 5.813,0.917 0.156,0.198 10 false ● 5.854,0.635 6.104,0.948 0.25,0.313 18 false 4 6.615,1.219 6.771,1.417 0.156,0.198 10 false ● 6.823,1.135 7.073,1.448 0.25,0.313 18 false 4 4.406,1.188 4.656,1.5 0.25,0.313 18 false 5 5.469,1.74 5.719,2.052 0.25,0.313 18 false 5 6.469,2.198 6.719,2.51 0.25,0.313 18 false 5 3.26,3.615 3.573,3.813 0.313,0.198 10 false x 4

Procedure Part Name Code
Z101186

Z101188

Z101187

1 BENCH TYPE REAR SEAT CUSHION ASSEMBLY - (Click here) - -
2 REAR SEAT CUSHION LOCK HOOK 72693 - - -
3 BENCH TYPE REAR SEATBACK ASSEMBLY - (Click here) - -
4 REAR SEATBACK HOLDER 71398A - - -
5 REAR NO. 1 SEATBACK SET BRACKET 71891 (Click here) - -

*1 REAR SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) *2 REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR)
*3 REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (FLOOR ANCHOR) - -
● Non-reusable part - -

CAUTION / NOTICE / HINT

CAUTION:
B543257

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



HINT:

Move both front seats to the frontmost position and fold them forward.


PROCEDURE

Hide 1.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

a.
B602678C02
4.198,4.688 5.323,4.688 true 3.656,1.302 3.969,1.302 true 4.365,5.031 5.49,5.031 true 2.615,1.177 3.406,1.177 true 2.229,3.479 2.365,3.771 0.135,0.292 18 true i 3.719,3.802 3.854,4.094 0.135,0.292 18 true i 4.917,1.635 5.177,1.865 0.26,0.229 12 true *A 5.354,4.594 5.667,4.792 0.313,0.198 10 false *a 4,1.188 4.198,1.396 0.198,0.208 10 true *b 3.292,2.521 3.469,2.813 0.177,0.292 18 true ii 1.281,1.646 1.51,1.948 0.229,0.302 18 true iii 5.448,1.594 5.677,1.896 0.229,0.302 18 true iii 6.458,1.521 6.688,1.823 0.229,0.302 18 true iv 5.521,4.938 5.833,5.135 0.313,0.198 10 false *1 2.396,1.073 2.594,1.26 0.198,0.188 10 false *c 0.708,1.615 0.969,1.844 0.26,0.229 12 true *A 3.469,4.365 3.604,4.656 0.135,0.292 18 true i 3.063,0.625 3.24,0.917 0.177,0.292 18 true ii 6.167,1.625 6.427,1.854 0.26,0.229 12 true *B 0.896,2.313 1.125,2.615 0.229,0.302 18 true v
*A w/ Seat Heater System *B w/ Occupant Detection Sensor
*1 Rear Seat Cushion Lock Hook - -
*a Front Hook *b Rear Hook
*c Seatback Frame - -
V113146

Place Hands Here
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)
V113149

Carry out in this Direction


i.

Place your hand in the position beside the front hook as shown in the illustration and lift the front end of bench type rear seat cushion assembly in the removal direction (1) to detach the front hook from the rear seat cushion lock hook.

NOTICE:
·

Be sure to detach the front hook one at a time.

·

Be sure to hold the parts of the bench type rear seat cushion assembly directly next to the front hook when lifting it. Lifting a different part may deform the cushion frame.

·

If the front hook is detached, replace the rear seat cushion lock hook with a new one.




ii.

Pull in the removal direction (2) to detach the rear hook.


iii.

w/ Seat Heater System:

1. Disconnect the 2 connectors.


iv.

w/ Occupant Detection Sensor:

1. Disconnect the connector and detach the clamp.


v.

Remove and carry the bench type rear seat cushion assembly out of the vehicle as shown in the illustration.

NOTICE:

Do not damage the bench type rear seat cushion assembly, body exterior or interior parts.




Hide 72693 2.REMOVE REAR SEAT CUSHION LOCK HOOK

a.
B591339


Hide 3.REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY

a.
B591340C02
4.156,0.594 4.906,0.594 true 4.25,0.875 5,0.875 true 2.719,4.927 2.854,5.208 0.135,0.281 18 true i 3.927,4.927 4.063,5.208 0.135,0.281 18 true i 1.25,1.771 1.417,2.052 0.167,0.281 18 true ii 0.333,2.333 0.542,2.615 0.208,0.281 18 true iii 3.542,4.125 3.708,4.406 0.167,0.281 18 true ii 1.469,3.615 1.677,3.896 0.208,0.281 18 true iv 3.135,3.885 3.344,4.167 0.208,0.281 18 true iv 4.219,4.01 4.427,4.292 0.208,0.281 18 true iv 6.188,4.229 6.396,4.51 0.208,0.281 18 true iv 4.938,0.49 5.25,0.688 0.313,0.198 10 false *a 5.042,0.781 5.354,0.979 0.313,0.198 10 false *1 2.729,2.281 2.938,2.563 0.208,0.281 18 true v 4.063,2.354 4.271,2.635 0.208,0.281 18 true v 5.313,2.375 5.521,2.656 0.208,0.281 18 true v 2.156,1.917 2.365,2.198 0.208,0.281 18 true vi
*1 Rear Seatback Holder - -
*a Rear Hook - -
V113147

Lift up in this Direction
V113148

Carry out in this Direction
V100135

Bolt A
V100136

Connector
V100137

Bolt B
V100138

Bolt C


i.

Remove the 2 bolts A and floor anchor of the rear seat outer belt assembly RH and rear seat outer belt assembly LH.


ii.

Disconnect the 2 connectors.


iii.

Loosen the bolt B and remove the floor anchor of the rear seat inner with center belt assembly RH.


iv.

Remove the 4 bolts C.


v.

Lift the bench type rear seatback assembly up as shown in the illustration to detach the rear hook from the rear seatback holder.

NOTICE:

If the rear hook is detached, replace the rear seatback holder with a new one.



vi.

Remove and carry the bench type rear seatback assembly out of the vehicle as shown in the illustration.

NOTICE:
·

Carrying the bench type rear seatback assembly from the vehicle must be performed by multiple people.

·

Do not damage the bench type rear seatback assembly, body exterior or interior parts.





Hide 71398A 4.REMOVE REAR SEATBACK HOLDER

a.
B591341C01
0,0 0,0 false
V113147

Remove in this Direction - -



Hide 71891 5.REMOVE REAR NO. 1 SEATBACK SET BRACKET

Z101186

HINT:

Perform this procedure when replacing the rear No. 1 seatback set bracket.



a.
B591342