| *A | w/ Seat Heater System | *B | w/ Climate Control Seat System |
| *1 | REAR SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR) | *2 | REAR SEAT OUTER BELT ASSEMBLY RH (FLOOR ANCHOR) |
| *3 | REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (FLOOR ANCHOR) | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Move both front seats to the frontmost position and fold them forward.
71891
1.INSTALL REAR NO. 1 SEATBACK SET BRACKET
71398A
2.INSTALL REAR SEATBACK HOLDER
3.INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY
| *1 | Rear Seatback Holder | - | - |
| *a | Rear Hook | *b | Protruding Part |
| *c | Location Pin | *d | Body Protrusion |
|
Carry in in this Direction |
|
Insert in this Direction |
|
Bolt A |
|
Connector |
|
Bolt B |
|
Bolt C |
Carry the bench type rear seatback assembly into the vehicle as shown in the illustration.
Carrying the bench type rear seatback assembly into the vehicle must be performed by multiple people.
Do not damage the bench type rear seatback assembly, body exterior or interior parts.
Insert the rear hook to the rear seatback holder as shown in the illustration.
Install the 4 bolts C.
Tighten the bolt B and install the floor anchor of the rear seat inner with center belt assembly RH.
Do not allow the anchor part of the rear seat inner with center belt assembly RH to overlap the protruding part.
Connect the 2 connectors.
Install the floor anchor of the rear seat outer belt assembly RH and rear seat outer belt assembly LH with the 2 bolts A.
When installing, make sure that the body protrusion comes between the location pins.
72693
4.INSTALL REAR SEAT CUSHION LOCK HOOK
5.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
| *A | w/ Seat Heater System | *B | w/ Occupant Detection Sensor |
| *1 | Rear Seat Cushion Lock Hook | - | - |
| *a | Front Hook | *b | Rear Hook |
| *c | Seatback Frame | - | - |
|
Carry in in this Direction |
|
Install in this Direction (1) |
|
Install in this Direction (2) | - | - |
Carry the bench type rear seat cushion assembly into the vehicle as shown in the illustration.
Do not damage the bench type rear seat cushion assembly, body exterior or interior parts.
w/ Seat Heater System:
1. Connect the 2 connectors.
w/ Occupant Detection Sensor:
1. Connect the connector and attach the clamp.
Attach the rear hook to the seatback frame as shown in the illustration.
Attach the front hook to the rear seat cushion lock hook as shown in the illustration.
Be sure to attach the front hook one at a time.
Make sure that the front hook is securely attached.