Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0448153 REFRIGERANT LINE A

HEATING / AIR CONDITIONING  REFRIGERANT LINE  INSTALLATION  


PROCEDURE

Hide 88718L 1.INSTALL PIPING CLAMP

a.

Remove the vinyl tape from the No. 1 liquid tube and liquid tube sub-assembly A.


b.

Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces of the No. 1 liquid tube.

Compressor Oil:

ND-OIL 11 or equivalent


NOTICE:

Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.



c.

Install the 2 O-rings to the No. 1 liquid tube.

NOTICE:

Keep the O-rings and O-ring fitting surfaces free of foreign matter.



d.

Install the No. 1 liquid tube to the liquid tube sub-assembly A.

NOTICE:
·

Make sure not to cut the O-ring while installing it. (Cut O-rings cannot be installed.)

·

Check that the assemblies are securely engaged.




e.
E273286C07
0.667,0.333 0.979,0.531 0.313,0.198 10 false *a 2.354,0.333 2.667,0.531 0.313,0.198 10 false *b 0.083,0.583 0.396,0.781 0.313,0.198 10 false *c 1.792,0.531 2.104,0.729 0.313,0.198 10 false *d
*a Correct
*b Incorrect
*c No Gap
*d Gap


Install the piping clamp to the No. 1 liquid tube and liquid tube sub-assembly A.

NOTICE:

Make sure that the piping clamp is engaged securely with no gap.



Hide 2.INSTALL HEADLIGHT ASSEMBLY LH

Hide 3.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

Hide 53295 6.INSTALL LOWER RADIATOR AIR DEFLECTOR

Hide 53292A 7.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 53291B 8.INSTALL RADIATOR COVER PLATE