Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0448154 BLOWER UNIT A

HEATING / AIR CONDITIONING  BLOWER UNIT  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E456028N03
0.229,0.563 6.927,4.229 6.698,3.667 3.521,4.24 3.521,4.479 false 5.74,1.823 5.74,2.344 false 2.958,1.99 3.417,2.198 3.417,2.198 3.698,2.198 true 3.448,4.49 3.729,4.771 0.281,0.281 18 false 1 5.677,2.354 5.958,2.708 0.281,0.354 18 false 3 3.781,2.052 4.063,2.406 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 AIR CONDITIONER UNIT ASSEMBLY - - - -
2 NO. 1 COOLER UNIT DRAIN HOSE 88539 - - -
3 BLOWER ASSEMBLY 87130D - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Steering sensor (Including removal and installation) Steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
No. 1 blower damper servo sub-assembly Servo motor initialization DTC output (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

When removing the air conditioning radiator damper servo sub-assembly, reinstallation is easier to perform if the following conditions are set before disconnecting the negative (-) battery terminal.

Item Condition
Air vent damper position Face
Set temperature Max cool

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 88539 2.SEPARATE NO. 1 COOLER UNIT DRAIN HOSE

a.
E456029


Hide 87130D 3.REMOVE BLOWER ASSEMBLY

a.
E456030