| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | COOLER DRYER | 88474 | ( )
|
- | - |
| *1 | CAP | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
|
Compressor oil ND-OIL 11 or equivalent | - | - |
88474
1.INSTALL COOLER DRYER
| *a | Modulator | - | - |
Using needle-nose pliers, install a new cooler dryer to the modulator.
Sufficiently apply compressor oil to the O-ring and the fitting surface of a new cap.
ND-OIL 11 or equivalent
Keep the O-ring and O-ring fitting surface free of foreign matter.
Using a 14 mm straight hexagon socket wrench, install the cap to the modulator.
Make sure not to cut the O-ring while installing it. (Cut O-rings cannot be installed.)