Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU
RM37H0E _57 Power Source / Network _095302 NETWORKING _0448172 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E455139N01
3.333,1.292 4.958,3.438 1.625,2.146 5.063,0.521 6.865,3.427 1.802,2.906 5.865,1.229 6.365,1.229 false 1.833,2.99 2.333,2.99 false 0.583,1.781 0.917,1.781 false 2.177,1.969 2.677,1.969 false 3.802,3.156 3.969,3.156 3.969,3.156 4.104,2.885 false 5.563,3.135 5.729,3.135 5.729,3.135 5.865,2.865 false 1.25,1.563 1.563,1.76 0.313,0.198 10 false x 2 6.448,1.125 6.729,1.479 0.281,0.354 18 false 2 0.417,1.667 0.698,2.021 0.281,0.354 18 false 4 2.729,1.844 3.01,2.198 0.281,0.354 18 false 1 2.396,2.896 2.76,3.25 0.365,0.354 10 false *1 3.375,1.323 3.75,1.563 0.375,0.24 12 false *A 5.125,0.542 5.5,0.781 0.375,0.24 12 false *B 5.396,3 5.677,3.354 0.281,0.354 18 false 3 3.635,3.042 3.917,3.396 0.281,0.354 18 false 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 FRONT DOOR SCUFF PLATE LH 67914B - - -
2 NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55607 - - -
3 FRONT FLOOR FRONT CARPET ASSEMBLY 58510C - - -
4 NETWORK GATEWAY ECU 89111 - - -

*A for LHD *B for RHD
*1 FLOOR WIRE - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during network gateway ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function when Necessary Procedures are not Performed Link
Central gateway ECU (network gateway ECU) Update ECU security key Vehicle control history (RoB) are stored (Click here)

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure below is for LHD vehicles.



PROCEDURE

Hide 67914B 1.REMOVE FRONT DOOR SCUFF PLATE LH

a.

Use the same procedure described for the RH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL


Hide 55607 2.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

Hide 58510C 3.REMOVE FRONT FLOOR FRONT CARPET ASSEMBLY

a.

for LHD:

E455130C01
0,0 0,0 false
V113147

Remove in this Direction
V100155

Fastener



b.

for RHD:

E455122C01
0,0 0,0 false
V113147

Remove in this Direction
V100155

Fastener



Hide 89111 4.REMOVE NETWORK GATEWAY ECU

a.
E455131C01
6.302,0.417 6.635,0.417 true 2.042,0.854 2.323,0.854 true 6.135,0.323 6.344,0.521 0.208,0.198 10 true *b 1.875,0.771 2.083,0.969 0.208,0.198 10 true *a
*a Clamp *b Guide
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)