Home › Vehicle Interior › LIGHTING (INT) › INTERIOR ILLUMINATION LIGHT (for Roof)
RM37H0E _58 Vehicle Interior _095306 LIGHTING (INT) _0448281 INTERIOR ILLUMINATION LIGHT(for Roof) A

LIGHTING (INT)  INTERIOR ILLUMINATION LIGHT(for Roof)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E457751E01
4.115,2.521 4.365,2.885 4.365,2.885 4.552,2.885 false 2.719,1.417 3.135,1.417 false 3.479,0.635 3.823,0.635 false 6.479,0.219 6.833,0.219 false 4.635,2.729 4.917,3.083 0.281,0.354 18 false 2 3.885,0.5 4.167,0.854 0.281,0.354 18 false 3 2.51,1.26 2.729,1.542 0.219,0.281 18 false 4 6.281,0.052 6.563,0.406 0.281,0.354 18 false 1

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 ROOF HEADLINING ASSEMBLY 63310 - - -
3 NO. 1 ROOF SILENCER PAD 63341 - - -
4 INTERIOR ILLUMINATION LIGHT SUB-ASSEMBLY 81081 - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during interior illumination light sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane Tracing Assist System Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision System
Adaptive high beam system


·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 63310 2.REMOVE ROOF HEADLINING ASSEMBLY

Hide 63341 3.REMOVE NO. 1 ROOF SILENCER PAD

Hide 81081 4.REMOVE INTERIOR ILLUMINATION LIGHT SUB-ASSEMBLY

a.
E454189C01
0,0 0,0 false
V100155

Fastening Tape - -