The headlight ECU sub-assembly performs adaptive high beam system control based on forward recognition information from the forward recognition camera.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B2437 | Camera High Temperature Malfunction | Detection condition:
Ignition switch is ON and automatic light control sensor recognizes that it is nighttime Malfunction status:
High temperature condition signals are received from forward recognition camera Malfunction duration:
- |
·
Check vehicle usage environment (history of usage in a high temperature environment) ·
Forward recognition camera |
AFS | A |
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
When the forward recognition camera is replaced with a new one, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.
Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.
for Sequential Recognition:
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)
for One Time Recognition:
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)
for Driving Adjustment:
Click hereADAS / AD>ADVANCED DRIVER ASSISTANCE SYSTEM>FRONT CAMERA>DRIVING ADJUSTMENT
DTC B2437 is only stored when it has been determined that it is dark based on the automatic light control sensor.
Pre-procedure1
None
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Cover the automatic light control sensor.
Turn the ignition switch to ON.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B2437 is not output | A |
| B2437 is output | B |
Post-procedure1
None
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Move the vehicle to a cool place and ensure that the forward recognition camera is within the normal operating temperature.
Procedure1
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
Post-procedure1
None
NEXT
Pre-procedure1
Cover the automatic light control sensor.
Turn the ignition switch to ON.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| B2437 is not output | A |
| B2437 is output | B |
Post-procedure1
None
A
B