The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during forward recognition camera removal/installation are shown below.
When replacing the forward recognition camera, replace it with a new one.
Replace the forward recognition camera if there is any foreign matter on the camera lens.
Do not touch the camera lens or the front windshield glass in front of the camera.
If the forward recognition camera has been struck or dropped, replace it with a new one.
When replacing the windshield glass of a vehicle equipped with a forward recognition camera, make sure to use a Toyota genuine part. If a non-Toyota genuine part is used, the forward recognition camera may not be able to be installed due to a missing bracket. Also the dynamic radar cruise control system, front camera system, lane tracing assist system, road sign assist system, pre-collision system, adaptive high beam system or automatic high beam system may not operate properly due to a difference in the transmissivity or black ceramic border.
75631L
1.REMOVE FRONT ROOF TOP GARNISH
86466E
2.REMOVE NO. 2 FORWARD RECOGNITION COVER
|
|
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
86466D
3.REMOVE NO. 1 FORWARD RECOGNITION COVER
|
|
|
Remove in this Direction | - | - |
86464A
4.REMOVE FORWARD RECOGNITION LATCH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
8646C
5.REMOVE FORWARD RECOGNITION CAMERA
|
|
|
Remove in this Direction | - | - |