The main body ECU (multiplex network body ECU) determines the status of the automatic high beam system based on the automatic high beam system signal from the forward recognition camera.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system | ·
Front camera system ·
Pre-collision system ·
Dynamic radar cruise control system ·
Lane tracing assist system ·
Hybrid control system ·
Electronically controlled brake system ·
CAN communication system ·
Forward recognition camera ·
Main body ECU (multiplex network body ECU) |
Main Body | A |
The lighting system uses the CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the automatic high beam system after confirming that the communication systems are functioning properly.
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Speed sensor malfunction
Yaw rate sensor malfunction
Steering sensor malfunction
CAN communication system
Pre-procedure1
Enter the following menus: System Select / Health Check.
Procedure1
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only B124B is output | A |
| B124B is output at the same time | B |
Post-procedure1
None
A
B
Check if a dynamic radar cruise control system, lane tracing assist system, road sign assist system or pre-collision system warning message are displayed on meter the multi-information display.
No dynamic radar cruise control system, lane tracing assist system and pre-collision system warning messages are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG