63260A
1.REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
2.REMOVE SLIDING ROOF REAR SIDE GARNISH RH
3.REMOVE SLIDING ROOF REAR SIDE GARNISH LH
Use the same procedure described for the RH side.
4.REMOVE SLIDING ROOF HOUSING CENTER FRAME
Using a T25 "TORX" socket wrench, remove the 4 "TORX" screws and sliding roof housing center frame.
5.REMOVE SLIDING ROOF SUNSHADE GUIDE RH
| *1 | Sliding Roof Sunshade Guide RH | - | - |
| *a | Back Side | - | - |
|
Remove in this Direction (1) |
|
Remove in this Direction (1) |
6.REMOVE SLIDING ROOF SUNSHADE GUIDE LH
Use the same procedure described for the RH side.
63306
7.DISCONNECT SUNSHADE TRIM SUB-ASSEMBLY
| *a | Part (A) | - | - |
|
Remove in this Direction | - | - |
Using a screwdriver with its tip wrapped with protective tape, detach the claw and remove part (A) as shown in the illustration.
Tape the screwdriver tip before use.
8.REMOVE SLIDING ROOF SUNSHADE PLATE RH
| *1 | Sliding Roof Sunshade Plate RH | - | - |
Using a screwdriver with its tip wrapped with protective tape, detach the claw of the sliding roof sunshade plate RH.
Tape the screwdriver tip before use.
| *1 | Sliding Roof Sunshade Plate RH | - | - |
|
Remove in this Direction | - | - |
Using a screwdriver with its tip wrapped with protective tape, remove the sunshade trim sub-assembly with sliding roof sunshade plate RH as shown in the illustration.
Tape the screwdriver tip before use.
9.REMOVE SLIDING ROOF SUNSHADE PLATE LH
Use the same procedure described for the RH side.
63306
10.REMOVE SUNSHADE TRIM SUB-ASSEMBLY
| *a | Retractor Cap | - | - |
|
Push |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) | - | - |
Push the retractor cap, lift up the sunshade trim sub-assembly in the direction of the arrow (1) and then remove it in the direction of the arrow (2) as shown in the illustration.
To prevent the sunshade trim sub-assembly from being damaged, fully push in the RH side retractor cap before lifting the sunshade trim sub-assembly to separate it from the slide roof rail sub-assembly.