| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | MULTIPLEX TILT AND TELESCOPIC ECU | 89227 | - | - | - |
| 2 | STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY | 45020B | ( )
|
- | - |
| *1 | STEERING LOCK SET BOLT | - | - |
| ● | Non-reusable part | - | - |
Do not drop the steering lock actuator or upper bracket assembly, strike it with tools or subject it toimpacts.
If the steering lock actuator or upper bracket assembly is subjected to an impact, replace it with a newone.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89227
1.INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
45020B
2.INSTALL STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY
|
|
Secure the steering column assembly in a vise between aluminum plates.
Do not overtighten the vise.
Do not clamp the steering lock actuator or upper bracket assembly in the vise.
Install the steering lock actuator or upper bracket assembly with 2 new steering lock set bolts, and tighten the bolts until they break off.