| *A | for LHD | - | - |
| *1 | LOCK NUT | - | - |
| ● | Non-reusable part | - | - |
| *A | for RHD | - | - |
| *1 | LOCK NUT | - | - |
| ● | Non-reusable part | - | - |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
44250
1.SECURE RACK AND PINION POWER STEERING GEAR ASSEMBLY
| *a | Protective Tape | - | - |
Using SST, secure the rack and pinion power steering gear assembly in a vise.
Wrap SST with protective tape before use.
2.REMOVE WIRE HARNESS CLAMP BRACKET (for RHD)
45470
3.REMOVE TIE ROD ASSEMBLY LH
| *a | Matchmark | - | - |
Put matchmarks on the tie rod assembly LH, lock nut and steering rack end sub-assembly.
Remove the tie rod assembly LH and lock nut.
45460
4.REMOVE TIE ROD ASSEMBLY RH
Perform the same procedure as for the LH side.
45535B
5.REMOVE STEERING RACK BOOT CLIP (for LH Side)
45535B
6.REMOVE STEERING RACK BOOT CLIP (for RH Side)
Perform the same procedure as for the LH side.
45536A
7.REMOVE NO. 2 STEERING RACK BOOT CLAMP (for LH Side)
Using a screwdriver, remove the No. 2 steering rack boot clamp as shown in the illustration.
Be careful not to damage the No. 2 steering rack boot.
45536A
8.REMOVE NO. 2 STEERING RACK BOOT CLAMP (for RH Side)
Perform the same procedure as for the LH side.
45536
9.REMOVE NO. 2 STEERING RACK BOOT
|
|
45535
10.REMOVE NO. 1 STEERING RACK BOOT
Perform the same procedure as for the No. 2 steering rack boot.