Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM
RM37H0E _58 Vehicle Interior _095313 DOOR LOCK _0452394 POWER DOOR LOCK CONTROL SYSTEM J

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch  


DESCRIPTION

The main body ECU (multiplex network body ECU) receives switch signals from the multiplex network master switch assembly via LIN communication system. The main body ECU (multiplex network body ECU) activates the door lock motor on each door according to these signals.

WIRING DIAGRAM

B479908E02
0.281,2.833 1.927,3.208 1.646,0.375 10 false Main Body ECU (Multiplex Network Body ECU) 2.906,2.198 4.604,2.573 1.698,0.375 10 false Front Multiplex Network Door ECU (for Driver Door) 5.208,2.021 6.792,2.417 1.583,0.396 10 false Multiplex Network Master Switch Assembly 0.573,3.406 2.188,3.583 1.615,0.177 10 false : LIN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

The power door lock control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power door lock control system after confirming that the communication systems are functioning properly.

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.



PROCEDURE

1.CHECK POWER WINDOW CONTROL SYSTEM
a.

Check that the power window operates normally via multiplex network master switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

Each power window operates normally.



Result:
Proceed to
OK
NG



OK

REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

NG

2.READ VALUE USING GTS (Door Lock Switch Status, Door Unlock Switch Status)
2.READ VALUE USING GTS (Door Lock Switch Status, Door Unlock Switch Status)
a.

Read the Data List according to the display on the GTS.

Body Electrical > Master Switch > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Door Lock Switch Status Multiplex network master switch assembly lock signal OFF or ON OFF: Lock side of multiplex network master switch assembly not pushed
ON: Lock side of multiplex network master switch assembly pushed
-
Door Unlock Switch Status Multiplex network master switch assembly unlock signal OFF or ON OFF: Unlock side of multiplex network master switch assembly not pushed
ON: Unlock side of multiplex network master switch assembly pushed
-
Body Electrical > Master Switch > Data List
Tester Display
Door Lock Switch Status
Door Unlock Switch Status
50003 148 18,19
OK:

On the GTS screen, ON or OFF is displayed for each item according to the table above.



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY