Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM37H0E _59 Vehicle Exterior _095314 DOOR / HATCH _0452982 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B380786C01
0.646,0.177 0.958,0.333 0.313,0.156 10 false *a 2.427,0.167 2.74,0.323 0.313,0.156 10 false *b
*a Centering Bolt
*b Standard Bolt


HINT:
·

Centering bolts are used to mount the hood hinge and hood lock assembly. The hood and hood lock assembly cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY

a.

Check that the clearance measurements of areas "A" through "D" are within each standard range.

B602528N01
1.427,2.625 1.583,2.823 0.156,0.198 10 false A 1.615,0.323 1.771,0.521 0.156,0.198 10 false B 4.052,0.24 4.208,0.438 0.156,0.198 10 false C 5.698,0.219 5.854,0.417 0.156,0.198 10 false D

Standard Clearance:
Area Measurement Area Measurement
A 4.6 to 8.6 mm (0.181 to 0.339 in.) B 2.0 to 6.0 mm (0.079 to 0.236 in.)
C 3.7 to 6.7 mm (0.146 to 0.264 in.) D 2.5 to 5.5 mm (0.098 to 0.217 in.)



Hide 53301 2.ADJUST HOOD SUB-ASSEMBLY

a.
B602529

Horizontally and vertically adjust the hood.

i.

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fender by moving the hood.


iii.

Tighten the 4 hinge bolts after adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.
B602530

Adjust the height of the front end of the hood using the hood bumper cushions.

i.

Adjust the 2 hood bumper cushions so that the heights of the hood and fenders are aligned.



c.
B602531

Adjust the hood lock assembly.

i.

Remove the upper radiator support seal.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL


ii.

Remove the radiator cover plate.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL


iii.

Remove the lower radiator air deflector.

Click hereEngine / Hybrid System>FC CONTROL>FC STACK>REMOVAL


iv.

Loosen the 3 bolts.


v.

Adjust the hood lock assembly and tighten the 3 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


vi.

Install the lower radiator air deflector.


vii.

Install the radiator cover plate.


viii.

Install the upper radiator support seal.