Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM37H0E _59 Vehicle Exterior _095314 DOOR / HATCH _0452983 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B608618N02
5.74,1.875 6.073,1.875 false 6.104,2.854 6.469,2.854 false 5.865,2.75 6.146,3.104 0.281,0.354 18 false 1 6.208,1.76 6.406,2.115 0.198,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 HOOD SUPPORT ASSEMBLY 53440D (Click here) - -
2 HOOD STAY BRACKET 53337A - - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 53440D 1.REMOVE HOOD SUPPORT ASSEMBLY

Z101186

CAUTION:
·
B392756

Do not perform work if the vehicle hood is not securely supported.

·

The hood could fall, resulting in injury.



NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

Do not push sideways on the cylinder because the rod may bend.




a.
B627311N01
1.573,0.063 2.948,0.417 1.375,0.354 18 false i, ii

i.

Using a thin-bladed screwdriver with its tip wrapped in protective tape, remove the 2 stop rings along their grooves.

HINT:

Tape the thin-bladed screwdriver tip before use.



ii.

Disengage the 2 ball joints to remove the hood support assembly.

NOTICE:

Remove the hood support assembly while holding the hood by hand.




Hide 53337A 2.REMOVE HOOD STAY BRACKET

a.
B602535