| ● | Non-reusable part | - | - |
64461
1.INSTALL LUGGAGE COMPARTMENT DOOR WEATHERSTRIP
Using non-residue solvent, remove any non-drying sealer on the body.
While avoiding the luggage compartment door, temporarily install a new luggage compartment door weatherstrip.
When installing, make sure that non-drying sealer does not adhere to the body and luggage compartment door.
58387
2.INSTALL REAR FLOOR FINISH PLATE
64701
3.INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
64572
4.INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER LH
|
Double-sided Tape | - | - |
Clean the surface of the vehicle body.
Remove any remaining double-sided tape from the vehicle body.
Wipe off any adhesive residue with cleaner.
Using a heat light, heat a new luggage compartment door hinge cover LH and the vehicle body surface.
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
| Part | Temperature |
|---|---|
| Luggage compartment door hinge cover LH | 20 to 30°C (68 to 86°F) |
Remove the peeling paper from the face of the luggage compartment door hinge cover LH.
Attach the clip and install the luggage compartment door hinge cover LH as shown in the illustration.
64571B
5.INSTALL LUGGAGE COMPARTMENT DOOR HINGE COVER RH
|
|
64714N
6.INSTALL NO. 1 LUGGAGE COMPARTMENT UPPER COVER LH
|
Double-sided Tape | - | - |
Clean the surface of the vehicle body.
Remove any remaining double-sided tape from the vehicle body.
Wipe off any adhesive residue with cleaner.
Using a heat light, heat a new No. 1 luggage compartment upper cover LH and the vehicle body surface.
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
| Part | Temperature |
|---|---|
| No. 1 luggage compartment upper cover LH | 20 to 30°C (68 to 86°F) |
Remove the peeling paper from the face of the No. 1 luggage compartment upper cover LH.
Attach the clip and install the No. 1 luggage compartment upper cover LH as shown in the illustration.
64713J
7.INSTALL NO. 1 LUGGAGE COMPARTMENT UPPER COVER RH
|
|