Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM37H0E _59 Vehicle Exterior _095305 WINDOW / GLASS _0453652 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch  


DESCRIPTION

If the manual up and down function operates normally but the auto up and down function does not, then fail-safe mode may be functioning.

If power window initialization has not been performed, the auto up and down function will not operate.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

WIRING DIAGRAM

for LHD, w/o Reverse Shift-linked Mirror:


B527846E16
0.719,2.729 2.625,3.146 1.906,0.417 10 false Front Power Window Regulator Motor Assembly RH 0.719,2.563 1.031,2.76 0.313,0.198 10 false E2 1.198,1.469 1.51,1.667 0.313,0.198 10 false IC 1.198,1.781 1.51,1.979 0.313,0.198 10 false IC 1.938,1.344 2.552,1.542 0.615,0.198 10 false AUTO 3.99,1.344 4.604,1.542 0.615,0.198 10 false AUTO 2.469,1.344 2.625,1.542 0.156,0.198 10 false 4 3.76,1.344 4.073,1.604 0.313,0.26 10 false 8 4.729,1.021 5.302,1.24 0.573,0.219 10 false Up Auto 4.646,1.615 5.365,1.844 0.719,0.229 10 false Down Auto 5.635,1.344 6.094,1.542 0.458,0.198 10 false GND 6.063,1.354 6.281,1.615 0.219,0.26 10 false 7 4.188,2.51 5.74,2.969 1.552,0.458 10 false Power Window Regulator Switch Assembly 4.188,2.323 4.5,2.521 0.313,0.198 10 false E13


for LHD, w/ Reverse Shift-linked Mirror:


B494695E16
0.25,2.677 2.198,3.063 1.948,0.385 10 false Front Power Window Regulator Motor Assembly RH 0.25,2.51 0.563,2.708 0.313,0.198 10 false E2 0.698,1.448 1.01,1.646 0.313,0.198 10 false IC 0.698,1.75 1.01,1.948 0.313,0.198 10 false IC 1.458,1.302 2.073,1.5 0.615,0.198 10 false AUTO 1.969,1.302 2.125,1.5 0.156,0.198 10 false 4 2.625,1.302 2.781,1.5 0.156,0.198 10 false 8 2.854,1.313 3.469,1.51 0.615,0.198 10 false AUTO 4.49,1.313 4.948,1.51 0.458,0.198 10 false GND 4.906,1.313 5.063,1.51 0.156,0.198 10 false 7 5.49,1.313 5.646,1.51 0.156,0.198 10 false 9 5.729,1.427 6.344,1.625 0.615,0.198 10 false SGND 3.573,0.99 4.177,1.229 0.604,0.24 10 false Up Auto 3.521,1.615 4.24,1.844 0.719,0.229 10 false Down Auto 3.042,2.26 3.354,2.458 0.313,0.198 10 false E13 3.042,2.438 4.604,2.802 1.563,0.365 10 false Power Window Regulator Switch Assembly 5.469,2.5 6.948,2.875 1.479,0.375 10 false Front Multiplex Network Door ECU RH 5.458,2.344 5.771,2.542 0.313,0.198 10 false E7


for RHD, w/o Reverse Shift-linked Mirror:


B527846E17
0.719,2.729 2.625,3.146 1.906,0.417 10 false Front Power Window Regulator Motor Assembly LH 0.719,2.563 1.031,2.76 0.313,0.198 10 false E20 1.198,1.469 1.51,1.667 0.313,0.198 10 false IC 1.198,1.781 1.51,1.979 0.313,0.198 10 false IC 1.938,1.344 2.552,1.542 0.615,0.198 10 false AUTO 3.99,1.344 4.604,1.542 0.615,0.198 10 false AUTO 2.469,1.344 2.625,1.542 0.156,0.198 10 false 4 3.76,1.354 3.917,1.552 0.156,0.198 10 false 8 4.729,1.021 5.302,1.24 0.573,0.219 10 false Up Auto 4.646,1.615 5.365,1.844 0.719,0.229 10 false Down Auto 5.635,1.344 6.094,1.542 0.458,0.198 10 false GND 6.063,1.354 6.219,1.552 0.156,0.198 10 false 7 4.188,2.51 5.74,2.969 1.552,0.458 10 false Power Window Regulator Switch Assembly 4.188,2.323 4.5,2.521 0.313,0.198 10 false E31


for RHD, w/ Double Locking System:


B494695E17
0.25,2.677 2.198,3.063 1.948,0.385 10 false Front Power Window Regulator Motor Assembly LH 0.25,2.51 0.563,2.708 0.313,0.198 10 false H20 0.698,1.448 1.01,1.646 0.313,0.198 10 false IC 0.698,1.75 1.01,1.948 0.313,0.198 10 false IC 1.458,1.302 2.073,1.5 0.615,0.198 10 false AUTO 1.969,1.302 2.125,1.5 0.156,0.198 10 false 4 2.625,1.302 2.781,1.5 0.156,0.198 10 false 8 2.854,1.313 3.469,1.51 0.615,0.198 10 false AUTO 4.49,1.313 4.948,1.51 0.458,0.198 10 false GND 4.906,1.313 5.063,1.51 0.156,0.198 10 false 7 5.49,1.313 5.646,1.51 0.156,0.198 10 false 9 5.729,1.427 6.344,1.625 0.615,0.198 10 false SGND 3.573,0.99 4.177,1.229 0.604,0.24 10 false Up Auto 3.521,1.615 4.24,1.844 0.719,0.229 10 false Down Auto 3.073,2.26 3.385,2.458 0.313,0.198 10 false E31 3.042,2.438 4.604,2.802 1.563,0.365 10 false Power Window Regulator Switch Assembly 5.469,2.5 6.948,2.875 1.479,0.375 10 false Front Multiplex Network Door ECU LH 5.469,2.323 5.781,2.521 0.313,0.198 10 false H25


CAUTION / NOTICE / HINT

NOTICE:
·

If the front power window regulator motor assembly RH (for LHD) or front power window regulator motor assembly LH (for RHD) has been replaced with a new one, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

·

Check that the "P Window Auto Up" and "P Window Auto Down" power window control system customize settings are "ON" before proceeding with work.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>CUSTOMIZE PARAMETERS

·

After the catch protection function operates, the auto operation is not performed the first time auto up is performed. All auto up operations performed after the first operate normally.



HINT:

If the pulse sensor built into the front power window regulator motor assembly RH is malfunctioning, the power window control system enters fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the power window regulator switch assembly at the auto up position, and opened manually by pushing down the power window regulator switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>FAIL-SAFE CHART


PROCEDURE

1.READ VALUE USING GTS (P-DOOR MOTOR)
a.

Using the GTS, read the data for the condition when the power window regulator switch assembly was operated.

Body Electrical > P-Door Motor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
P Door P/W Auto SW Front passenger door power window auto switch signal OFF or ON OFF: Front passenger door power window auto switch not being operated
ON: Front passenger door power window auto switch being operated
-
Body Electrical > P-Door Motor > Data List
Tester Display
P Door P/W Auto SW
50003 144 1
OK:

On the GTS screen, ON or OFF is displayed accordingly.



Result:
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C



A

2.PERFORM INITIALIZATION

B

3.PERFORM INITIALIZATION

C

4.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
2.PERFORM INITIALIZATION
a.

Initialize the front power window regulator motor assembly RH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

OK:

Power window system operates normally.



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

3.PERFORM INITIALIZATION
a.

Initialize the front power window regulator motor assembly LH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

OK:

Power window system operates normally.



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

4.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY

Click hereVehicle Exterior>WINDOW / GLASS>FRONT PASSENGER SIDE POWER WINDOW SWITCH>INSPECTION

Result:
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C



A

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH)

B

6.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH)

C

REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH)
a.

Disconnect the E31 power window regulator switch assembly connector.


b.

Disconnect the E20 front power window regulator motor assembly RH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(E20,E31)Location & Routing

Click Connector(E20)Body>Front Door Wire LH / Front Door Wire RH>Front Power Window Regulator Motor Assembly LH

Click Connector(E31)Body>Front Door Wire LH / Front Door Wire RH>Power Window Regulator Switch Assembly

E20-4 (AUTO) - E31-8 (AUTO) Always Below 1 Ω
E20-4 (AUTO) or E31-8 (AUTO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH)
a.

Disconnect the E13 power window regulator switch assembly connector.


b.

Disconnect the E2 front power window regulator motor assembly LH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(E2,E13)Location & Routing

Click Connector(E2)Body>Front Door Wire LH / Front Door Wire RH>Front Power Window Regulator Motor Assembly RH

Click Connector(E13)Body>Front Door Wire LH / Front Door Wire RH>Power Window Regulator Switch Assembly

E2-4 (AUTO) - E13-8 (AUTO) Always Below 1 Ω
E2-4 (AUTO) or E13-8 (AUTO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR