Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM37H0E _59 Vehicle Exterior _095305 WINDOW / GLASS _0453652 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Rear Power Window LH Auto Up / Down Function does not Operate with Rear Power Window Switch LH  


DESCRIPTION

If the manual up and down function operates normally but the auto up and down function does not, then fail-safe mode may be functioning.

If power window initialization has not been performed, the auto up and down function will not operate.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

WIRING DIAGRAM

w/o Double Locking System:


B527846E19
0.719,2.729 2.604,3.188 1.885,0.458 10 false Rear Power Window Regulator Motor Assembly LH 0.719,2.563 1.031,2.76 0.313,0.198 10 false F12 1.198,1.469 1.51,1.667 0.313,0.198 10 false IC 1.198,1.781 1.51,1.979 0.313,0.198 10 false IC 1.938,1.344 2.552,1.542 0.615,0.198 10 false AUTO 3.99,1.344 4.604,1.542 0.615,0.198 10 false AUTO 2.469,1.344 2.625,1.542 0.156,0.198 10 false 4 3.76,1.354 3.917,1.552 0.156,0.198 10 false 8 4.729,1.021 5.302,1.24 0.573,0.219 10 false Up Auto 4.646,1.615 5.365,1.844 0.719,0.229 10 false Down Auto 5.635,1.344 6.094,1.542 0.458,0.198 10 false GND 6.063,1.354 6.219,1.552 0.156,0.198 10 false 7 4.188,2.51 6.052,3.021 1.865,0.51 10 false Rear Power Window Regulator Switch Assembly LH 4.188,2.323 4.5,2.521 0.313,0.198 10 false F21


w/ Double Locking System:


B494695E18
0.25,2.677 2.198,3.063 1.948,0.385 10 false Rear Power Window Regulator Motor Assembly LH 0.25,2.51 0.563,2.708 0.313,0.198 10 false F12 0.698,1.448 1.01,1.646 0.313,0.198 10 false IC 0.698,1.75 1.01,1.948 0.313,0.198 10 false IC 1.458,1.302 2.073,1.5 0.615,0.198 10 false AUTO 1.969,1.302 2.125,1.5 0.156,0.198 10 false 4 2.625,1.302 2.781,1.5 0.156,0.198 10 false 8 2.854,1.313 3.469,1.51 0.615,0.198 10 false AUTO 4.49,1.313 4.948,1.51 0.458,0.198 10 false GND 4.906,1.313 5.063,1.51 0.156,0.198 10 false 7 5.49,1.313 5.646,1.51 0.156,0.198 10 false 9 5.729,1.427 6.344,1.625 0.615,0.198 10 false SGND 3.573,0.99 4.177,1.229 0.604,0.24 10 false Up Auto 3.521,1.615 4.24,1.844 0.719,0.229 10 false Down Auto 2.917,2.26 3.229,2.458 0.313,0.198 10 false F21 2.917,2.438 4.813,2.865 1.896,0.427 10 false Rear Power Window Regulator Switch Assembly LH 5.469,2.5 6.948,2.875 1.479,0.375 10 false Rear Multiplex Network Door ECU LH 5.469,2.333 5.781,2.531 0.313,0.198 10 false F16


CAUTION / NOTICE / HINT

NOTICE:
·

If the rear power window regulator motor assembly LH has been replaced with a new one, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

·

Check that the "RL Window Auto Up" and "RL Window Auto Down" power window control system customize settings are "ON" before proceeding with work.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>CUSTOMIZE PARAMETERS

·

After the catch protection function operates, the auto operation is not performed the first time auto up is performed. All auto up operations performed after the first operate normally.



HINT:

If the pulse sensor built into the rear power window regulator motor assembly LH is malfunctioning, the power window control system enters fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the rear power window regulator switch assembly LH at the auto up position, and opened manually by pushing down the rear power window regulator switch assembly LH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>FAIL-SAFE CHART


PROCEDURE

1.READ VALUE USING GTS (RL-DOOR MOTOR)
a.

Using the GTS, read the data for the condition when the rear power window regulator switch assembly LH was operated.

Body Electrical > RL-Door Motor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RL Door P/W Auto SW Rear LH door power window auto switch signal OFF or ON OFF: Rear LH door power window auto switch not being operated
ON: Rear LH door power window auto switch being operated
-
Body Electrical > RL-Door Motor > Data List
Tester Display
RL Door P/W Auto SW
50003 146 1
OK:

On the GTS screen, ON or OFF is displayed accordingly.



Result:
Proceed to
OK
NG



OK

2.PERFORM INITIALIZATION

NG

3.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH
2.PERFORM INITIALIZATION
a.

Initialize the rear power window regulator motor assembly LH.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION

OK:

Power window system operates normally.



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

3.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH

OK

4.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH)

NG

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH

4.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH - REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH)
a.

Disconnect the F21 rear power window regulator switch assembly LH connector.


b.

Disconnect the F12 rear power window regulator motor assembly LH connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(F12,F21)Location & Routing

Click Connector(F12)Body>No. 1 Rear Door Wire / No. 2 Rear Door Wire>Rear Power Window Regulator Motor Assembly LH

Click Connector(F21)Body>No. 1 Rear Door Wire / No. 2 Rear Door Wire>Rear Power Window Regulator Switch Assembly LH

F12-4 (AUTO) - F21-8 (AUTO) Always Below 1 Ω
F12-4 (AUTO) or F21-8 (AUTO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR