| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL LH | - | ( )
|
- | - |
| 2 | REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY | 84810D | ( )
|
- | - |
| *1 | REAR DOOR ARMREST BASE PANEL LH | - | - |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
84810D
2.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
Using a thin-bladed screwdriver, detach the claw and remove the rear power window regulator switch assembly from the rear door armrest base panel LH.
Tape the thin-bladed screwdriver tip before use.