Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM37H0E _54 Brake _096746 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0454014 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

COMPONENTS (INSTALLATION)
C446175N02
6,2.208 7,2.375 1,0.167 5.958,2.167 7.042,2.417 1.083,0.25 3.917,4.583 4.5,4.583 false 4.635,2.885 5,2.885 false 6.385,0.25 6.802,0.25 false 5.833,2.458 5.833,2.292 5.833,2.292 6,2.292 false 3.75,4.458 4.083,4.792 0.333,0.333 18 false 2 6.208,0.104 6.542,0.521 0.333,0.417 18 false 3 4.427,2.75 4.76,3.083 0.333,0.333 18 false 1 6.063,2.229 7.063,2.563 1,0.333 8 false 8.5 (87, 75 in.*lbf)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR SPEED SENSOR LH 89546 (Click here) - -
2 REAR WHEEL - - - -
3 CHECK FOR SPEED SENSOR SIGNAL - (Click here) - -

V111893

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) - -

CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 89546 1.INSTALL REAR SPEED SENSOR LH

Z101186

NOTICE:
·

The rear speed sensor is easily damaged. When installing the rear speed sensor to the rear axle hub LH, do not use excessive force to rotate and install it.

·

Prevent foreign matter from attaching to the sensor tip.

·

Do not drop the sensor. If the sensor has been dropped, replace the sensor with a new one.

·

Remove any dirt or foreign matter on and around the connector before performing this step.

·

Do not allow water, oil or dirt to enter the connector.




Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

Hide 2.INSTALL REAR WHEEL