| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | WHEEL ASSEMBLY | - | - | - | - |
| 2 | TIRE PRESSURE WARNING VALVE AND TRANSMITTER | 42607 | ( )
|
- | - |
| *1 | TIRE VALVE CAP | *2 | VALVE CORE |
| *3 | NUT | *4 | WASHER |
| *5 | GROMMET | *6 | DISC WHEEL |
| *7 | TIRE | *8 | TIRE PRESSURE MONITOR SENSOR |
| *9 | TUBELESS TIRE VALVE | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning valve and transmitter removal/installation are shown below.
| Replacement Part or Procedure | Necessary Procedures | Effects/Inoperative when not Performed | Link |
|---|---|---|---|
| Tire pressure warning valve and transmitter | ·
Register transmitter ID ·
Initialize tire pressure warning system ·
Perform tire position identification |
·
When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates. ·
Tire pressure warning function |
for Initialization:@@@@
for Registration:@@@@ |
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE TIRE
42607
2.REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
| *1 | Tire | - | - |
| *a | Shoe | *b | 10 to 20 mm (0.394 to 0.787 in.) |
Remove the tire valve cap.
Keep the removed tire valve cap.
Remove the valve core to release the air from the tire.
Make sure that a sufficient amount of air has been released.
Using a 11 mm deep socket wrench, remove the nut and washer.
Drop the tire pressure warning valve and transmitter with grommet into the tire.
The grommet may remain attached to the rim.
Using a tire remover, remove the tire from the disc wheel.
Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.
Set the tire remover shoe as shown in the illustration.
Take out the tire pressure warning valve and transmitter with grommet from the tire.
Remove the grommet from the tire pressure warning valve and transmitter.
Using a T10 "TORX" socket wrench, remove the bolt and tire pressure monitor sensor from the tubeless tire valve.