Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>PRECAUTION
Inspect the fuse for circuits related to this system before performing the following procedure.
Disconnect the D68 telematics transceiver connector.
Disconnect the H10 map light assembly (manual [SOS] switch) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(H10)Location & Routingewd_type=routing;type=c;code=H10 Click Connector(H10)Body>No. 1 Roof Wire>Map Light Assemblyewd_type=component;type=c;code=H10;pinno=5 |
||
| H10-5 (RRID) - Body Ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D68,H10)Location & Routingewd_type=routing;type=c,c;code=D68,H10 Click Connector(D68)Instrument Panel>Instrument Panel Wire>Telematics Transceiverewd_type=component;type=c;code=D68;pinno=3 Click Connector(H10)Body>No. 1 Roof Wire>Map Light Assemblyewd_type=component;type=c;code=H10;pinno=9 |
||
| D68-3 (SIG-) - H10-9 (GND3) | Always | Below 1 Ω |
| D68-3 (SIG-) or H10-9 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Map Light Assembly [Manual (SOS) Switch]) |
Remove the map light assembly (manual [SOS] switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Apply auxiliary battery voltage to the connector.
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → 5 (RRID)
Auxiliary battery negative (-) → 9 (GND3) |
Always | Manual (SOS) switch illumination comes on |
Check if the manual (SOS) switch illumination comes on.
The manual (SOS) switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telematics transceiver with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT