This DTC is stored when a connection malfunction, such as an open, is detected in the wire harness between the stereo component equalizer assembly and No. 3 speaker assembly with box.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| B1363 | Speaker Circuit 2 | Open in the speaker circuit | ·
Harness or connector ·
No. 3 speaker assembly with box ·
Stereo component equalizer assembly |
ASC | A |
Using the GTS, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Sound | ASC system | ON or OFF | - |
| Tester Display |
|---|
| Sound |
Sound is output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>ASC SPEAKER (for Floor)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Pre-procedure1
Disconnect the D104 stereo component equalizer assembly connector.
Disconnect the D28 No. 3 speaker assembly with box connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
Click Location & Routing(D104,D28)Location & Routingewd_type=routing;type=c,c;code=D104,D28 Click Connector(D104)Instrument Panel>Instrument Panel Wire>Stereo Component Equalizer Assemblyewd_type=component;type=c;code=D104;pinno=2,10 Click Connector(D28)Instrument Panel>Instrument Panel Wire>No. 3 Speaker with Box Assemblyewd_type=component;type=c;code=D28;pinno=2,1 |
||
| D104-2(SPO+) - D28-2(SPI+) | Always | Below 1 Ω |
| D104-10(SPO-) - D28-1(SPI-) | Always | Below 1 Ω |
| D104-2(SPO+) or D28-2(SPI+) - Body ground | Always | 10 kΩ or higher |
| D104-10(SPO-) or D28-1(SPI-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG