Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR
RM37H0E _58 Vehicle Interior _095300 HEATING / AIR CONDITIONING _0448158 AMBIENT TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  AMBIENT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
E456117N01
1.406,1.906 0.969,1.906 false 3.792,1.458 3.396,1.458 false 0.823,1.76 1.104,2.115 0.281,0.354 18 false 1 3.844,1.313 4.125,1.667 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 FRONT BUMPER ASSEMBLY - - - -
2 THERMISTOR ASSEMBLY 88790B - - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ambienT temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Front bumper assembly (Including removal and installation)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking assist- sensor system

·

Parking support brake system

·

Advanced park


w/ Advanced Park:
(Click here)
w/o Advanced Park:
(Click here)
Front television camera view adjustment Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 88790B 2.REMOVE THERMISTOR ASSEMBLY

a.
E456118