Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER
RM37H0E _59 Vehicle Exterior _095315 EXTERIOR PANELS / TRIM _0448282 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B604586N05
5.583,2.469 5.667,2.635 5.667,2.635 5.917,2.635 false 0.875,5.073 1.125,5.073 1.125,5.073 1.229,4.865 false 2.875,2.531 3.125,2.531 3.125,2.531 3.208,2.365 false 3.104,0.729 3.354,0.729 3.354,0.729 3.438,0.896 false 4.802,4.385 4.885,4.552 4.885,4.552 5.135,4.552 false 5.188,3.833 5.271,4 5.271,4 5.521,4 false 4.448,3.865 4.698,3.865 4.698,3.865 4.781,4.031 false 4.792,3.24 5.042,3.24 5.042,3.24 5.125,3.406 false 1.042,1.156 1.292,1.156 1.292,1.156 1.375,1.323 false 0.698,1.667 0.948,1.667 0.948,1.667 1.031,1.833 false 1.792,1.469 1.875,1.635 1.875,1.635 2.125,1.635 false 1.458,1.99 1.542,2.156 1.542,2.156 1.792,2.156 false 1.125,2.719 1.365,2.719 false 3.615,4.208 3.854,4.208 false 6.365,0.552 6.781,0.552 false 6.875,0.167 6.375,0.167 false 2.042,3.031 2.354,3.229 0.313,0.198 10 false x 3 2.26,3.292 2.573,3.49 0.313,0.198 10 false x 2 6.5,1.625 6.813,1.823 0.313,0.198 10 false x 6 4.385,1.698 4.698,1.896 0.313,0.198 10 false x 6 4.271,0.313 4.583,0.51 0.313,0.198 10 false x 6 6.188,0.042 6.469,0.396 0.281,0.354 18 false 1 6.188,0.417 6.469,0.771 0.281,0.354 18 false 2 5.969,2.5 6.25,2.854 0.281,0.354 18 false 3 2.938,0.594 3.219,0.948 0.281,0.354 18 false 4 0.875,1.01 1.156,1.365 0.281,0.354 18 false 8 0.698,4.948 0.979,5.302 0.281,0.354 18 false 6 2.708,2.396 2.99,2.75 0.281,0.354 18 false 5 3.906,4.146 4.219,4.344 0.313,0.198 10 false *1 3.26,5.552 3.573,5.75 0.313,0.198 10 false x 8 1.417,2.656 1.729,2.854 0.313,0.198 10 false *2 2.198,1.51 2.479,1.865 0.281,0.354 18 false 7 1.875,2.031 2.156,2.385 0.281,0.354 18 false 7 4.625,3.115 4.906,3.469 0.281,0.354 18 false 7 4.292,3.74 4.573,4.094 0.281,0.354 18 false 7 0.531,1.542 0.813,1.896 0.281,0.354 18 false 8 5.594,3.865 5.875,4.219 0.281,0.354 18 false 8 5.229,4.427 5.51,4.781 0.281,0.354 18 false 8

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 UPPER RADIATOR SUPPORT SEAL 53292A - - -
4 RADIATOR COVER PLATE 53291B - - -
5 LOWER RADIATOR AIR DEFLECTOR 53295 - - -
6 FRONT BUMPER ASSEMBLY - (Click here) - -
7 PIN HOLD CLIP 47749F - - -
8 FRONT FENDER LINER RETAINER 53879H - - -

*1 FRONT BUMPER SIDE MOUNTING BRACKET LH *2 FRONT BUMPER SIDE MOUNTING BRACKET RH

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front bumper assembly removal/installation are shown below.

Necessary Procedures after parts removed/installed/replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function when Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Ultrasonic sensor (Including removal and installation)
·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

TOYOTA Parking assist- sensor system

·

Parking support brake system

·

Advanced park


w/ Advanced Park:
(Click here)
w/o Advanced Park:
(Click here)
·

Front bumper assembly (Including removal and installation)

·

Radiator grille assembly (Including removal and installation)


·

Measurement of ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Front television camera view adjustment Panoramic view monitor system (Click here)
Front television camera assembly (Including removal and installation) Front television camera view adjustment Panoramic view monitor system (Click here)
Front television camera assembly, front bumper assembly or radiator grille
·

Television camera view adjustment

HINT:

Replacement or removal and installation of 2 or more parts



Panoramic view monitor system

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Adaptive high beam system


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -




PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL

Hide 53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 53291B 4.REMOVE RADIATOR COVER PLATE

Hide 53295 5.REMOVE LOWER RADIATOR AIR DEFLECTOR

Hide 6.REMOVE FRONT BUMPER ASSEMBLY

a.
B595795N02
1.271,0.24 1.552,0.594 0.281,0.354 18 false i

i.

Put protective tape around the front bumper assembly.



b.
B595796C01
0.135,0.063 0.417,0.417 0.281,0.354 18 false i

i.

Remove the 8 screws.



c.
B599760C06
6.063,1.25 6.615,1.333 true 3.719,2.625 4,2.979 0.281,0.354 18 false i 6.281,1.615 6.469,1.854 0.188,0.24 18 true ii 6.635,1.271 6.854,1.448 0.219,0.177 10 true *1 4.333,0.458 4.563,0.698 0.229,0.24 18 true iv 6.115,0.958 6.344,1.198 0.229,0.24 18 true iii
*1 Front Bumper Side Mounting Bracket LH - -


i.

Using a screwdriver, detach the claw as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



ii.

Fold back the front fender splash shield sub-assembly LH and remove the screw.


iii.

Detach the claw and remove the front bumper side mounting bracket LH.


iv.

Detach the claw.



d.

Use the same procedure for the other side.


e.
B604583C01
2.823,1.531 2.708,1.26 true 2.677,0.406 2.594,0.573 true 0.281,1.615 1.448,1.896 1.167,0.281 18 true i, ii, iii, iv, v 4.354,2.167 4.531,2.417 0.177,0.25 18 true v 2.75,1.49 2.99,1.708 0.24,0.219 12 true *A 2.615,0.24 2.854,0.458 0.24,0.219 12 true *A
*A w/ Panoramic View Monitor System - -
V113147

Remove in this Direction
V100135

Bolt
V100136

Connector
V100137

Clip


i.

Disconnect each connector.


ii.

Remove the 3 bolts.


iii.

Remove the 2 clips.


iv.

Detach the claw.


v.

Detach the guide and remove the front bumper assembly as shown in the illustration.



Hide 47749F 7.REMOVE PIN HOLD CLIP

a.
B595799C01
0,0 0,0 false
V113147

Remove in this Direction - -



Hide 53879H 8.REMOVE FRONT FENDER LINER RETAINER

a.
B595800C01
0,0 0,0 false
V113147

Remove in this Direction - -