After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Click herePower Source / Network>BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION
| Result | Proceed to |
|---|---|
| Auxiliary battery is OK | A |
| Recharge auxiliary battery | |
| Replace auxiliary battery | B |
A
B
Charge the auxiliary battery.
| Proceed to |
|---|
| NEXT |
NEXT
Click herePower Source / Network>BATTERY / CHARGING>AUXILIARY BATTERY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
With the brake pedal depressed, move the shift lever to select neutral (N).
Push the P position switch (parking switch) to select park (P).
Turn the ignition switch off.
Leave the vehicle as is for 60 seconds or more.
Do not connect the GTS.
Do not depress the brake pedal.
Do not open/close any of the doors.
Check that the electronic shift lever system operates correctly.
| Proceed to |
|---|
| NEXT |
NEXT