Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
RM37H0E _53 Suspension _096766 TIRE PRESSURE MONITORING _0454878 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2176  Receiver Error  


DESCRIPTION

Tire pressure warning valve and transmitter signals are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority
C2176 Receiver Error Malfunction in the tire pressure warning ECU and receiver internal circuit Tire pressure warning ECU and receiver Tire Pressure Monitor A

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, first use the GTS to record all of the current IDs and registered tires with transmitters (4 or 5 tires) of the tire pressure warning valve and transmitter registered to the tire pressure warning ECU and receiver.

·

It is necessary to perform initializationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION after registrationSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK VEHICLE TYPE
Result:
Result Proceed to
excluding JPD20R-CEDSSW (w/ Panic Switch) A
for JPD20R-CEDSSW (w/ Panic Switch) B



A

2.CLEAR DTC

B

4.CLEAR DTC
2.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Chassis > Tire Pressure Monitor > Clear DTCs
50002 203

Result:
Proceed to
NEXT


Post-procedure1

a.

Turn the ignition switch off.



NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT
a.

Turn the ignition switch to ON and check for DTCs.

Chassis > Tire Pressure Monitor > Trouble Codes
50001 203

Result:
Result Proceed to
C2176 is not output A
C2176 is output B



A

B

4.CLEAR DTC

Pre-procedure1

a.

None


Procedure1

a.

Clear the DTCs.

Chassis > Tire Pressure Monitor > Clear DTCs
50002 203

Result:
Proceed to
NEXT


Post-procedure1

a.

Turn the ignition switch off.



NEXT

5.CHECK DTC OUTPUT
5.CHECK DTC OUTPUT
a.

Turn the ignition switch to ON and check for DTCs.

Chassis > Tire Pressure Monitor > Trouble Codes
50001 203

Result:
Result Proceed to
C2176 is not output A
C2176 is output B



A

B