Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER (for Quarter Pillar)
RM37H0E _53 Suspension _096766 TIRE PRESSURE MONITORING _0454055 TIRE PRESSURE WARNING RECEIVER(for Quarter Pillar) A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER(for Quarter Pillar)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C448149N01
5.99,2.417 6.49,2.417 true 6.146,1.531 6.646,1.531 true 5.583,1.271 5.896,1.271 5.896,1.271 5.969,1.042 true 6.594,0.865 6.802,0.865 true 5.26,3.844 5.76,3.844 true 3.49,3.188 3.99,3.188 true 4.083,0.802 4.583,0.802 true 6.219,0.417 6.354,0.26 6.354,0.26 6.552,0.26 true 4.219,5.313 4.219,4.469 4.219,4.469 4.417,4.469 true 5.865,1.896 6.365,1.896 true 6.531,2.323 6.688,2.521 0.156,0.198 10 false ● 6.708,1.438 6.865,1.635 0.156,0.198 10 false ● 5.396,1.167 5.552,1.365 0.156,0.198 10 false ● 6.854,0.781 7.01,0.979 0.156,0.198 10 false ● 4.063,3.031 4.344,3.385 0.281,0.354 18 false 1 4.5,4.313 4.781,4.667 0.281,0.354 18 false 2 4.927,3.646 5.208,4 0.281,0.354 18 false 3 4.646,0.646 4.927,1 0.281,0.354 18 false 4 6.427,1.729 6.708,2.083 0.281,0.354 18 false 5 6.625,0.104 6.906,0.458 0.281,0.354 18 false 6

Procedure Part Name Code
Z101186

Z101188

Z101187

1 REAR BENCH TYPE REAR SEATBACK ASSEMBLY - - - -
2 REAR INSIDE DOOR SCUFF PLATE LH 67918F - - -
3 REAR SEAT SIDE GARNISH LH 62552F - - -
4 INNER ROOF SIDE GARNISH COVER LH 62488A - - -
5 INNER ROOF SIDE GARNISH ASSEMBLY LH 62480A - - -
6 ROOF SIDE RAIL GARNISH ASSEMBLY LH 62440 - - -

● Non-reusable part - -

C448150N01
3.156,0.844 3.156,0.219 3.156,0.219 3.49,0.219 true 3.958,0.073 4.24,0.427 0.281,0.354 18 false 7

Procedure Part Name Code
Z101186

Z101188

Z101187

7 TIRE PRESSURE WARNING ECU AND RECEIVER 89760C (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning receiver removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
Tire pressure warning ECU and receiver (electrical key and TPMS receiver assembly)
·

Register transmitter ID

·

Initialize tire pressure warning system

·

Perform tire position identification


·

When DTC detection conditions of "transmitter ID not received" DTC are met, tire pressure warning light blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


Initialization:(Click here)
Registration:(Click here)

PROCEDURE

Hide 1.REMOVE REAR BENCH TYPE REAR SEATBACK ASSEMBLY

Hide 67918F 2.REMOVE REAR INSIDE DOOR SCUFF PLATE LH

Hide 62552F 3.REMOVE REAR SEAT SIDE GARNISH LH

Hide 62488A 4.REMOVE INNER ROOF SIDE GARNISH COVER LH

Hide 62480A 5.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

Hide 62440 6.REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH

Hide 89760C 7.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

a.
C448151C02
0.354,0.031 1.229,0.333 0.875,0.302 18 false i - iii
V100135

bolt
V100136

Connector


i.

Disconnect the connector.


ii.

Remove the bolt.


iii.

Detach the 2 guides and tire pressure warning ECU and receiver.

NOTICE:
·

Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject itto impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with anew one.