Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
RM37H0E _53 Suspension _096766 TIRE PRESSURE MONITORING _0454878 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  Cannot Switch to Automatic ID Registration Mode  


DESCRIPTION

Operate the steering pad switch assembly, select "Change Wheel Set" on the multi-information display and press and hold the "OK" switch (steering pad switch assembly) until the tire pressure warning light blinks 3 times and the tire pressure warning valve and transmitter moves to the ID registration mode via the automatic ID registration function.

The main body ECU (multiplex network body ECU) receives signals from the combination meter assembly via the CAN communication line.

PROCEDURE

1.CHECK TEST MODE (TIRE PRESSURE WARNING RESET SWITCH CHECK [DTC C2198])
a.

Perform the test mode inspection and check for the tire pressure warning reset switch check item (DTC C2198).

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>TEST MODE PROCEDURE

Result:
Proceed to
NEXT




NEXT